that is perfect thank you! Was planning on getting the tremor fender flares and wanted to make sure that same wheel/tire size will sit about even and i think they do! Looks like about a 1” poke if im not mistaken.I didn't have any rubbing issues with the 275's and all crash bars.
If that even
That size will likely fit just fine. Best thing to do is try it out and adjust as needed once the tires are on.
I see two trucks and three trash dumpstersFinally got my wheel/tire and suspension set up
Wheels: Relations Race Wheels RR6-H, 17x8.5 0 offset in matte bronze
Tires: BFG k02, 285/70/17
Suspension: Fox 2.5 front and rear, front raised about 2.5"
Cut out rear intrusion beams, they were rubbing, cut out some fender liner that rubbed behind the tire, and BDS front intrusion beam. Fog light pockets removed to add dual light bracket.
Still some rubbing on the fender liner, I need to cut a bit more out, but doesn't seem to rub on any chassis parts!
Damn looks goodFinally got my wheel/tire and suspension set up
Wheels: Relations Race Wheels RR6-H, 17x8.5 0 offset in matte bronze
Tires: BFG k02, 285/70/17
Suspension: Fox 2.5 front and rear, front raised about 2.5"
Cut out rear intrusion beams, they were rubbing, cut out some fender liner that rubbed behind the tire, and BDS front intrusion beam. Fog light pockets removed to add dual light bracket.
Still some rubbing on the fender liner, I need to cut a bit more out, but doesn't seem to rub on any chassis parts!
How are you liking the standard OME lift? Your build is very similar to what I am trying to achieve! I want to go with 17x8 +20 with 33x10.5R17 tires. Except for crash bars, are you close to rubbing anywhere, even at full articulation? Thanks!Just installed new wheels and tires to go with my new lift.
Motegi Trailite 17x8.5 +18 offset
285/70/17 Cooper Discoverer At3 XLT Load Range E
Old man emu standard lift
Readylift intrusion bars
Tasteful poke, no rub.
I'm loving the setup so far - the wider tires feel a lot more planted, and the suspension is more firm but not harsh at all - just more planted. Totally with the money invested. As far as rubbing goes, I did trim the black aero thing that deflects air from in front of the front tires. Other than that, nothing. I would personally go with the 20mm offset in your situation - you'll still have tasteful poke, but it'll be just a bit less poke than my setup.
