What did you do to your Ranger today?

[AndyMedic]

Finished the bumper and installed, all new front and rear Diff fluid and transfer case. And Rough Country Diff Skid. Thanks to @Colo_Ranger for the hand installing also.
Just need to figure out the 4/7 pin plug at some point as there is no opening on the bumper for it.
Also updated my Livernois tuner and got the v5 tunes available I’ll install tomorrow after the dealer for my rear camera.

edited for before and after Side by side photo

Sponsored

 

[Colo_Ranger]

Can’t wait to experience the Livernois to see if I should upgrade.

 

[Russd]

Bought these for my last truck but never got around to finishing them. Made them bolt on like the white knuckle sliders.

 

[Tracy Bowman]

Thanks Duke. This has been a great truck and I've really enjoyed this forum. I've been in the Sierra forums and so far they don't look like such a fun/entertaining/helpful group as we've got here.

Well, please visit on here often. You will be missed!

 

[7Boomerang7]

Ok finished the front

 

[Venom_z89]

nice weld

Thank you. wish it was better but eh it'll hold.

 

[7Boomerang7]

Yeah the sound upgrade is worth it. Honestly I liked the stock sound, but after installing the new speakers with a small Alpine in dash amp and a new Kenwood head deck I can definitely see how foggy and less crisp and smooth the stock speakers were. The sound is beautiful and well balanced

 

[Venom_z89]

Bought these for my last truck but never got around to finishing them. Made them bolt on like the white knuckle sliders.

very nice

 

[AndyMedic]

Yeah the sound upgrade is worth it. Honestly I liked the stock sound, but after installing the new speakers with a small Alpine in dash amp and a new Kenwood head deck I can definitely see how foggy and less crisp and smooth the stock speakers were. The sound is beautiful and well balanced

what amp? And any inline connectors needed? Also link to speakers used? Thanks in advance! Not very good at audio and overwhelmed by all the choices.

 

[Paparoscoe]

Finally made the commitment to install the trailer brake controller. Had the package sitting around for a few weeks. Truly not to hard to install. Just a tedious job of removing trim pieces. Hooking into the third brake light wire was the worst part. Pinned the connectors wrong and it took a lot of patience to get it de-pinned again. Would rather swing wrenches any day.

 

[9zero1790]

Finished the bumper and installed, all new front and rear Diff fluid and transfer case. And Rough Country Diff Skid. Thanks to @Colo_Ranger for the hand installing also.
Just need to figure out the 4/7 pin plug at some point as there is no opening on the bumper for it.
Also updated my Livernois tuner and got the v5 tunes available I’ll install tomorrow after the dealer for my rear camera.

edited for before and after Side by side photo

looks great!

 

[AndyMedic]

Thanks @9zero1790

 

[9zero1790]

Today I finished cleaning everything out of it and took some pictures to put it up for sale.

no rule about owning one to be a member here rag chew ?

 

[puckdodger]

no rule about owning one to be a member here rag chew ?

I guess I could always hang around to remind people what a bitch the catch can install was....

 

[seasprite]

Look out here comes another picture of a sexy Velocity Blue Ranger with a new bed cover

And you know its good because it says........

Sponsored