Brett Fields
Well-Known Member
Rivnuts into the floor & wall
Rubber isolators threaded in
Compressor mounted in ARB Universal bracket.
Wired to Aux batteries.
Sponsored
Sponsored
On board Air setup on your Ranger
- Thread starter KnightRanger
- Start date
- Watchers 48
Rivnuts into the floor & wall
Rubber isolators threaded in
Compressor mounted in ARB Universal bracket.
Wired to Aux batteries.
Frenchy
Well-Known Member
- First Name
- Chris
- Joined
- Mar 15, 2020
- Threads
- 164
- Messages
- 7,541
- Reaction score
- 10,751
- Location
- Elizabeth, Colorado
- Vehicle(s)
- 2012 Nissan Frontier, 1994 F150 XL, 2022 Ford Transit
- Occupation
- Field Service Technician
Rivnuts are nice
Rivnuts into the floor & wall
Rubber isolators threaded in
Compressor mounted in ARB Universal bracket.
Wired to Aux batteries.
Brett Fields
Well-Known Member
I agree! Everyone should make friends with rivnuts. They make for very clean installs.
MrBusses
Well-Known Member
I am currently using a harbor freight 100 psi 12v air pump which works ok, just takes a while and gets hot. The ARB sets ups are out of my price range for the amount of off roading I will be doing but I think I will be going with the Milwaukee M18 inflator. Reviews have it doing 4 tires 15 psi to 30 in about 10 minutes or less. I already am invested in the M18 batteries at work so just need the tool and I will be set.
Colo_Ranger
Well-Known Member
I am finally happy with my install. ARB Single in the Decked ammo can. I will be moving the check to the back, so I can air up without opening the cans. Mostly for when its covered with my camp gear and cooler.
RangerAl87
Well-Known Member
- First Name
- al
- Joined
- Jul 26, 2020
- Threads
- 13
- Messages
- 65
- Reaction score
- 112
- Location
- Westchester,NY
- Vehicle(s)
- 2020 ford ranger XLT
- Occupation
- Tech
Any issue with thr elements getting into the ammo can , and damaging the compressor ?
I am finally happy with my install. ARB Single in the Decked ammo can. I will be moving the check to the back, so I can air up without opening the cans. Mostly for when its covered with my camp gear and cooler.
Colo_Ranger
Well-Known Member
Nothing yet. The only way water would get in is if I was submerged above the decked system. The top is sealed pretty good and routes water away from the tub.
Cali_Cactus_Ranger
New Member
- First Name
- Christian
- Joined
- May 10, 2022
- Threads
- 1
- Messages
- 2
- Reaction score
- 1
- Location
- Bay Area, CA
- Vehicle(s)
- 2021 XLT Ranger Sport 4x4
- Occupation
- Sales Ops Analyst, CRM Admin, Data Magician
Reviving this. Huge shout to Dmeyer302 for the photos. I ended up doing similar to him and it works great! I mounted my 6 gang auxbeam with another custom bracket next to the battery. Just need some split loom to tidy up that trigger wire. I'll probably route the quick connect to the rear bumper as well..
Sponsored
