What did you do to your Ranger today?

[Russd]

Woo-hoo! The fender flares are done!

I want one of those front bumpers?.

Sponsored

 

[Glocker]

I want one of those front bumpers?.

It was a major PITA to install but VERY worth it, in my humble opinion.

 

[IdahoRanger]

I’m just washing the bugs off True North as I post this.

It’s definitely an indoor day at the lake today.

Maybe it will drown the critters in the engine bay.

 

[AzScorpion]

I’m just washing the bugs off True North as I post this.

It’s definitely an indoor day at the lake today.

I wish it would rain like that here. Then I could just open the hood and let the rain clean all the dust off my engine bay. ?

 

[DukeCanBuildit]

Woo-hoo! The fender flares are done!

 

[Grumpaw]

I wish it would rain like that here. Then I could just open the hood and let the rain clean all the dust off my engine bay. ?

But then water would get into the sparkey pluggy holes....and you know where that will lead too !!!!!!!!

 

[AzScorpion]

But then water would get into the sparkey pluggy holes....and you know where that will lead too !!!!!!!!

Yup, another thread complaining about Ford. ?

 

[Doc]

Missed a spot, Dave!?

Between the fender gap

 

[DukeCanBuildit]

Maybe it will drown the critters in the engine bay.

I better go remove that engine cover and put some peanut butter in the spark plug well.

EDIT: Maybe mix in a bit of warfarin. ?

 

[AzScorpion]

I better go remove that engine cover and put some peanut butter in the spark plug well.

EDIT: Maybe mix in a bit of warfarin. ?

Even better! ?

 

[Crow_of_judgement]

No pictures because I'm lazy,

Changed the rear diff fluid today, 70k ish miles and the fluid still looked pretty decent. Magnet was plum full of metal shavings though

 

[Scatch85]

Added a 12 volt connection in the bed. Ford supplies power near but is too cheap to finish the job unless you cough up $$$ for a lariat.

Just got mine in too.

Just finished up another harness as well. Mounting this on the double antenna bracket I got then off to fight the firewall.

 

[Scatch85]

Is that the AVS cab light bar? How does it look on your truck? Any side shots of the truck with it installed?

Thanks

Looks good, lots of comments. I don't really notice much wind noise either, but don't trust my hearing.

The included rubber sleeve is no good. I just ran the bear wire down the pillar and used a trim tool to tuck it under the windshield. That didn't have an issue on the highway. I am thinking some black silicone but for now took an extra piece of the rubber door edge trim and it fits nicely.

Comes with posi-taps which is a bonus. Used one on the positive then went right to chassis ground on the other.

 

[jflogerzi]

Installed my JCR-Offroad engine cover. Spent more money due to this place. Did I need it? Nope but I sure wanted it

 

[Grumpaw]

Looks good, lots of comments. I don't really notice much wind noise either, but don't trust my hearing.

The included rubber sleeve is no good. I just ran the bear wire down the pillar and used a trim tool to tuck it under the windshield. That didn't have an issue on the highway. I am thinking some black silicone but for now took an extra piece of the rubber door edge trim and it fits nicely.

Comes with posi-taps which is a bonus. Used one on the positive then went right to chassis ground on the other.

The cab mounted USA Flag looks good !!!

Sponsored