jdagg2003
Member
I finally got around to contacting Truxedo and as expected they are sending out new rails and a new rubber seal, they seal was installed backwards, not sure if the rails where too short or if they weren't installed correctly by Linex but I guess we will see in a few days.I have the Truxedo lo pro. I suspect it was an installation issue with the Linex store I bought it at, but it doesn't seal well at all.
The foam bulkhead seal doesn't stay in place for more than a couple days without adjustment and the rails are bent on both sides at the bulkhead. Either the rails weren't installed far enough back or the rails are too short because the clamps on the actual cover only cover about an inch on the end of the rails causing the bend.
I haven't had a chance to talk with Truxedo but I know they have great customer service and will take care of it.
(Edit) I know the install was rushed because the tension on the top wasn't set at all, I guess it's technically possible that I over tensioned it but I set them exactly how it is shown in the manual.
Sponsored