At a quick glance I though those were the torx bits sticking out of the squash. I was like "what kind of crazy looking handle did he get"?? Then I put my readers on and saw the bits below.?Torx sockets. This truck is half metric and half torx ?.
It's harvest time and have to harden off the squash for the root cellar. They are heirlooms in inch size ?.At a quick glance I though those were the torx bits sticking out of the squash. I was like "what kind of crazy looking handle did he get"?? Then I put my readers on and saw the bits below.?
Love the look of those wheels!but man would you just look at these wheels!
My droopy BedRug saga continues ... last time I used 33 pound pull magnets and now I'm using 110 pound ones (https://www.amazon.com/dp/B08GCP8MXW).I got some magnets to try to hold my BedRug up. It keeps unsticking at the front, despite having wiped it well with rubbing alcohol. I think I must be trying to connect it too high. The magnets were not strong enough on their own (30 pound pull). I have a couple of 110 pound pull coming to try (N52s).
If that doesn't work, I have gobs of double-sided 3M tape and will wipe down the bed and the existing sticky side of the velcro 3M and place it there and a bit lower (I have it trying to stick to the angled part at the front of the bed).
These could be handy for something else. If all else fails, I can use them in my tool cabinet.
https://www.amazon.com/dp/B08C7SXBKZ
It's never held very well. When it first came loose, I used rubbing alcohol again but I think I'm sticking it up too high. You can't see it too well normally cause the rolling tonneau covers it up, but still ...
All six finally held a little, but that won't be enough. So I'll be lazy and try stronger ones, but the real solution is to use fresh 3M. Since it's the velcro backed one, I'll clean up the sticky side (the part that's supposed to be on the bed) and stick another layer of 3M on it (one inch wide's what I have) and see if that hold.
The BedRug itself can't go anywhere, the six tie downs are also holding it in place.
thanks! i like the look and the tech behind em so im pretty excited!Love the look of those wheels!
Where did you get the additional clamps? I don't trust the clams with my Leer tonneau.Plus, I installed the additional clamps that @RedDakooter05 told me about. My tonneau rails aren't going anywhere easily (plus if they did fall off, they'd get sucked to those magnets!). =D
Well, I wanted to make sure that Jeff Bezos is able to afford diesel for his 426 foot mega yacht, So I got them at Amazon:Where did you get the additional clamps? I don't trust the clams with my Leer tonneau.