What did you do to your Ranger today?

[KNI]

Today I filled the piss tank.

Or AdBlue, DEF, Heterobasidion repellent or what ever roundabout way you want to call it.

Sponsored

 

[Jake]

Installed the 5mm spacers I got from here: https://www.ebay.com/itm/203082068865
In preparation for these hopefully going on tomorrow.

 

[JJ101]

Made a standing divider between the wheel wells and the tailgate to keep the sandbags in place. It has already been an improvement on the wet roads, bring on the snow.

 

[DukeCanBuildit]

Have I been too subtle in asking for it?

Lol, I’m so far down the rabbit hole at this point it’s pitch black….you won’t be able to see me blink twice.

What you could do is toss me a safety line and tell me that I absolutely do not need an engine cover. I can have one delivered by Thursday….and my finger is hovering above the “Add to Cart” button as I type.

Blink, Blink.

I’m glad you got the cover - absolutely necessary equipment. Just looks wrong without it, especially if you have the Roush CAI. If you don’t, why not?

 

[Hirnlego]

I was cleaning the truck today and notice not only is there this hole that was capped in the rear but there is also one behind the front knuckle.

I feel your pain. Mine arrived today as well (we must’ve seen the same member’s post). Two hours into the install I was still trying to figure out the whole right side/left side conundrum when I finally said “Eff it!!” and just shoved one in. I must’ve guessed wrong because I had to use a mallet in addition to brute force to get them to seat properly. I just hope no one notices.

 

[Zeroedin]

I’m glad you got the cover - absolutely necessary equipment. Just looks wrong without it, especially if you have the Roush CAI. If you don’t, why not?

Lol, the Roush CAI is next on my list, along with a tune and Retrax bed cover. I’m waiting until January before dropping any more coin into the truck, primarily because my fun-money piggy bank has a hollow sound when I rattle it. Between watches, knives and the truck that damn pig is just constantly crapping money….and it won’t get fed again until the start of the new year.

 

[Zeroedin]

I was cleaning the truck today and notice not only is there this hole that was capped in the rear but there is also one behind the front knuckle.

Hadn’t noticed one up front yet. Fortunately, I have OCD (diagnosed and well controlled), so when I order a small part like that I have a tendency to order two….just in case I jack something up installing it or something falls off on a trail or in the car wash. So I have another set of plugs all set to go, assuming they’re the same diameter.

Crap. Almost 11 pm, I’m in my pajamas, about to settle in with the family for a movie…..and now I gotta go look around for this frikkin’ hole.

OCD; it has its good…..and it has its bad.

 

[RedDakooter05]

…..and now I gotta go look around for this frikkin’ hole.

Oh so many jokes to be said.

 

[Venom_z89]

Today I got to making light bar. Still waiting on one more light then to do the wiring.

 

[Venom_z89]

The lights and bracket

 

[OFC Ranger]

About done... (who am I kidding, these things are never really done)

 

[Jake]

Installed the 5mm spacers I got from here: https://www.ebay.com/itm/203082068865
In preparation for these hopefully going on tomorrow.

New tires are on.

 

[Stevescootz]

Underbody spray & ceramic coat complete. Added coloured lettering. I’m amazed it doesn’t come this way as it looks way better. But I guess it leaves room for customization!

 

[Venom_z89]

Test mock up. Tomorrow hopefully will have it fully wired and ditch lights installed too.

 

[Bsenecal]

Took her into the woods to get some pine bows for my wife to decorate. ?

That looks like it could be a snowmobile trail in the winter.
Brian

Sponsored