What did you do to your Ranger today?

[9zero1790]

Haha, it’s no joke, I have to back in too and if I need to get to my tools, I have to nose my truck out of the garage. I even anchored a wheel chock to the floor so I don’t back into the shelving.

So, I know just how you feel…

same here! i bolted a 2x8 to the floor and rubber wheel stopper so i dont hit anything lol. is that a 66 mustang i spy??

Sponsored

 

[DukeCanBuildit]

same here! i bolted a 2x8 to the floor and rubber wheel stopper so i dont hit anything lol. is that a 66 mustang i spy??

Maybe

Full disclosure - it’s not mine and I’m not sure what year it is. My neighbour borrowed it from his car club and just had it parked in there temporarily because the space was available that day.

 

[mr.wonderful]

Ordered my Turbosmart dual port bpv today from Summit Racing. Since I am in NorCal for another week, it means a trip over the summit to Reno to the Land of Race Car Parts tomorrow for pick-up. Following in my dad's footsteps since his jeep was pretty much built at Summit.

Emptied my catch can and replaced the o-rings

Applied door edge trim to the hole in my bumper cover for the winch lead to make it look a little more "professional"

Did not drive it

 

[Venom_z89]

GT500 calipers clear all around with no modifications.

 

[Figarou]

Man, that looks like a tight fit Mark!

No....THIS is a tight fit.

https://www.ranger5g.com/forum/threads/white-platinum-ranger-club-thread.1061/page-8#post-162232

 

[DukeCanBuildit]

No....THIS is a tight fit.

https://www.ranger5g.com/forum/threads/white-platinum-ranger-club-thread.1061/page-8#post-162232

C’mon, why, there’s a ton of room.

Man, it’s so cramped in there, you’d have to go outside to change your mind.

Here’s the view from my backup cam….

 

[Figarou]

C’mon, why, there’s a ton of room.

Man, it’s so cramped in there, you’d have to go outside to change your mind.

Here’s the view from my backup cam….

At least you can back in.

I won't be able to open the driver's door if I did that.

The only way is if I had a bench seat with no center console and the gear shift on the steering. I could slide over to the passenger side and get out.

 

[Scott D]

My collectible Supercab got its yearly oil change today. The reminder alert appears on the dash cluster every December.

Current milage is 4,792. I put 1,155 miles on it since last December.

It still looks very clean underneath. It has been driven in the rain maybe three times since I got it in October of 2020.

 

[seano3ca]

Wash, vac, and strategically placed pipe insulation to avoid water in plug wells. If weather permits tomorrow, I'll pull the #1 coil and boot to confirm nothing has made it in so far. We live in a rainy climate, but are experiencing the driest conditions I can remember, so I may not find anything anyhow.

 

[9zero1790]

No....THIS is a tight fit.

https://www.ranger5g.com/forum/threads/white-platinum-ranger-club-thread.1061/page-8#post-162232

My collectible Supercab got its yearly oil change today. The reminder alert appears on the dash cluster every December.

Current milage is 4,792. I put 1,155 miles on it since last December.

It still looks very clean underneath. It has been driven in the rain maybe three times since I got it in October of 2020.

boy is it clean under that ranger! mine looks like homemade stew underneath lol.

 

[Tremorky]

Tremor boards off….. Havoc HSTs going on. Maybe today. Maybe tomorrow or next year

 

[Tremorky]

Tremor boards off….. Havoc HSTs going on. Maybe today. Maybe tomorrow or next year

Well, this upgrade didn’t go as planned.

 

[underwhelmed]

First bath since September and a fresh coating of 303 touchless for the 2000 mile round trip to OK to bow hunt next week.

it was 65 and sunny so I had to do it.

 

[fjwlobo]

Well, this upgrade didn’t go as planned.

Can't tell by the picture. Is this the passenger side? Are the running boards designed to be installed on only one side? Could they have put two of the same sides in the box? Not sure if you tried to install the other side to see if it fits. Just a few thoughts.

 

[Tremorky]

Can't tell by the picture. Is this the passenger side? Are the running boards designed to be installed on only one side? Could they have put two of the same sides in the box? Not sure if you tried to install the other side to see if it fits. Just a few thoughts.

I thought maybe I had two of the same side at first but it appears the brackets I tacked in the wrong place. Other side is the same so guessing someone got their plans/measurements mixed up on this one. . I’m getting a refund and will put the Tremor boards back on. Oh well lol. May post the truck for sale soon anyway.

Sponsored