What did you do to your Ranger today?

[JohnDLG]

Fixed some paint chips with a touch up paint pen. After it all dried I then installed an AVS Aeroskin hood protector that I got on sale at Amazon. Hopefully it does a decent job of protecting the hood from chips.

Sponsored

 

[Figarou]

I was messing around in the DIY section last week and saw a post by "quangdog" dated back in 2020 where he did a nice DIY video. He and some of you made it look sooo easy that I just had to get a pair of these cheap LED puddle lamps from Amazon for myself. They arrived today so I snapped them on . Took all of 10 minutes.
Peer pressure is strong around here. You guys need to stop it! LOL

These are next. You have clear or smoked.

Sequential or normal blink. Links below. ?

POPMOTORZ Clear Lens LED Mirror Turn Signal Light - Normal Flash Amber Side Mirror Marker Lamps with 72LEDs - for Ranger T6 2012-2019 Raptor and Wildtrak, Everest U375 / UA 2015-2019, Pack of 2 https://www.amazon.com/dp/B09BR4TPXK/ref=cm_sw_r_apan_i_6MB9NFSPM6NERSQ9Z6NS


POPMOTORZ Smoked Lens LED Mirror Turn Signal Light - Amber Side Mirror Marker Lamps with 72 LEDs - Compatible With Ranger T6 2012-2019 Raptor and Wildtrak, Everest U375 / UA 2015-2019, Pack of 2 https://www.amazon.com/dp/B09BR23RJL/ref=cm_sw_r_apan_i_XWKE39XPV5GHJSA5HKJA

POPMOTORZ Sequential LED Mirror Turn Signal Light Clear Amber with 72LEDs Side Mirror Marker Lamps Compatible With Ranger T6 2012-2019 Raptor and Wildtrak, Everest U375 / UA 2015-2019, 2PCS https://www.amazon.com/dp/B09BTQ5L6R/ref=cm_sw_r_apan_i_CPK5HAQA1ZWRME1FAW26


POPMOTORZ Sequential LED Mirror Turn Signal Light Smoked Lens 72LEDs Side Mirror Marker Lamps Compatible with Ranger T6 2012-2019 Raptor and Wildtrak, Everest U375 / UA 2015-2019 2PCS https://www.amazon.com/dp/B09BQS5NQ2/ref=cm_sw_r_apan_i_XMCWJ54YTX7NBEFPHYCJ

 

[9zero1790]

today i finally installed new rear shocks. while under the truck i noticed how filthy she was so when the shocks were done i got out the power washer and soap foam blaster. poor truck still looks filthy. never ever again getting a black off road vehicle. every slight breeze scratches it and the first bit of dust or pollen makes it look like you have never washed it.

 

[RangerRandy]

These are next. You have clear or smoked.

Sequential or normal blink. Links below. ?

POPMOTORZ Clear Lens LED Mirror Turn Signal Light - Normal Flash Amber Side Mirror Marker Lamps with 72LEDs - for Ranger T6 2012-2019 Raptor and Wildtrak, Everest U375 / UA 2015-2019, Pack of 2 https://www.amazon.com/dp/B09BR4TPXK/ref=cm_sw_r_apan_i_6MB9NFSPM6NERSQ9Z6NS


POPMOTORZ Smoked Lens LED Mirror Turn Signal Light - Amber Side Mirror Marker Lamps with 72 LEDs - Compatible With Ranger T6 2012-2019 Raptor and Wildtrak, Everest U375 / UA 2015-2019, Pack of 2 https://www.amazon.com/dp/B09BR23RJL/ref=cm_sw_r_apan_i_XWKE39XPV5GHJSA5HKJA

POPMOTORZ Sequential LED Mirror Turn Signal Light Clear Amber with 72LEDs Side Mirror Marker Lamps Compatible With Ranger T6 2012-2019 Raptor and Wildtrak, Everest U375 / UA 2015-2019, 2PCS https://www.amazon.com/dp/B09BTQ5L6R/ref=cm_sw_r_apan_i_CPK5HAQA1ZWRME1FAW26


POPMOTORZ Sequential LED Mirror Turn Signal Light Smoked Lens 72LEDs Side Mirror Marker Lamps Compatible with Ranger T6 2012-2019 Raptor and Wildtrak, Everest U375 / UA 2015-2019 2PCS https://www.amazon.com/dp/B09BQS5NQ2/ref=cm_sw_r_apan_i_XMCWJ54YTX7NBEFPHYCJ

No!! I will not do it! Leave me alone! LOL

 

[gfitzge2]

Washed and detailed. Yesterday was third Rangerversary.

 

[Bob902]

Washed and detailed. Yesterday was third Rangerversary.

Looks sharp!!!!

 

[JohnnyO]

Tinted the quarter windows in the SC rear doors. My tinting skills are rusty, haven't done it in ages, but they came out okay. I like it so I'll probably do the rear window and doors. Didn't go real dark since PA cops are picky about tint.

 

[Hot Pepper Red Zeppelin]

Cleaned up the wiring for the battery maintainer by cutting out about 4 ft of extra wiring that was coiled up on top of battery.

 

[Rob09]

I tell you what I would like to do, remove the Ranger emblem on sides, and have one made that says F100! Any ideas where I could get this done? I believe the original Ranger was an F100..

 

[DangerRanger01]

Managed to get my lift and tires installed, and I have to say, what a difference it makes!

Stock Ride Height before installation.

For starters, the lift is the Rough Country 3" Lift kit w/ rear shock absorbers, Installation was fairly straightforward, up until the front diff drop, which Rough Country does give you instructions for, just not that great and you have to really wiggle around down there with a proper grinding tool to cut the original bracket out for the rear. Other than that everything went smooth, though if you are installing a lift (or a leveling kit for that matter) make sure to take your CV Axles out or you're going to have a hell of a time popping it back in. We did remove the front and rear crash bars, but after close inspection, it looks as if we could have left the front crash bars in as there is quite a bit of clearance in the front.

The rear was pretty straightforward, they give you composite plastic lift blocks and new u-bolts, and provide all the installation media, nuts, bolts, etc. the rear shocks are built really well, no complaints there and they do make a huge difference in rear ride quality over stock.

Though this is just a front spacer lift, I have to say the parts they give you have really great build quality, and I don't see anything wrong with the spacers or the installation media whatsoever.

The UCA's are built great and have a fairly thick powder coating on them and definitely have more heft than stock.

The truck wasn't much out of alignment after the install, but paying that extra $150 is just cheap insurance for your tires and bearings down the road.

As for wheels and tires, I went with a set of 18" Armed Offroad Infantry wheels w/ a +12 offset (these are a local brand that can only be purchased (as far as I know) from Canada Custom Autoworks, super nice rims, great build, no issues with the quality of the wheels at all and I love the look, and didn't have to pay an arm and a leg for a brand name *cough* FUEL *cough*

For rubber, I went with a set of 33x12.5 R18 Venom Power Terra Hunter R/T+ Tires. so far I am loving them, the road noise is to be expected but it's not abnormally loud for an R/T tire, not as quiet as the Ridge Grapplers but for the price, I'm not complaining. (plus they're 3 peak rated) I've heard a lot of horror stories about these tires being out-of-round, abnormal wear, and not balancing properly. I've had no issues with balancing, and they have been holding up great so far. These are a huge improvement over those stock Hankook tires they threw on from the factory, and being a 12 ply, it really helps the ride quality and stops the truck from feeling floaty.

I have noticed a significant KPL / MPG hit with this setup, but I don't mind considering it feels like a capable truck now, so far I've only lost 150 Km range (estimate from the fuel Estimate KM to Empty), and the Kilo per liter has gone from 12.5 highway to about 14.

Overall, I am super stoked with this setup and haven't had any issues thus far. Loving the look and knowing that I can get into sticky situations and feel confident the truck can get me out of it with her new shoes and ground clearance.

Ride height after installation, total height difference went from about 35" in the front and 37" in the rear to 40" and 40"

I highly recommend heading over to Canada Custom Autoworks if all the Canadian folk are looking for a great place to go for lifts, tires, bumpers etc. They are phenomenal and gave us a great deal. Overall paid about $3500 CAD for the entire setup (installed ourselves).

The disease of truck parts has now started haha.

 

[patipton]

Do you have a night shot with regular fog light on, then with the rough country on?

This is the only one I have with them on I’ll find a dark back road give me ma few days

 

[SFB]

No shit! Nice

 

[TVRangerSTX]

Washed and detailed. Yesterday was third Rangerversary.

Looks showroom new Greg!

 

[Adamcarr]

This is the only one I have with them on I’ll find a dark back road give me ma few days

Nice. Do uou have them on a switch or tapped into your fog light switch

 

[RRTruuck]

looks great! I like the side steps also. It appears you took off the front wheel valances. Did you take them off for looks or did you experience rubbing?

Took them off for looks. Also had to remove the front intrusion bars I was rubbing those in reverse

Sponsored