Replacing Rear Bumper End Cap 2019

[Chris Frazier]

Hello

Can an end cap be replaced without removing whole bumper assembly on a 2019 Ranger with sensors. Thanks

Sponsored

 

[ctechbob]

Nope. BTDT.

 

[Chris Frazier]

Thanks but thats terrible news. Thought it wouldn't be big job because it's a single piece unto itself. Couldn't find any YouTubes of anyone doing it.

 

[ctechbob]

It isn't a terrible job, but you'll probably break clips on the plastic cover and it will be much easier with help.

 

[Msfitoy]

What end caps are you referring to? My front bumper is steel all the way to the end (by the front tire)...

 

[DukeCanBuildit]

What end caps are you referring to? My front bumper is steel all the way to the end (by the front tire)...

I figured he was referring to this…

 

[Msfitoy]

I figured he was referring to this…

Correct...rear bumpers...but where's the end cap? It's still a full steel bumper to the end...

 

[Chris Frazier]

What end caps are you referring to? My front bumper is steel all the way to the end (by the front tire)...

The thread title: Replacing Rear Bumper End Cap 2019

 

[DukeCanBuildit]

Correct...rear bumpers...but where's the end cap? It's still a full steel bumper to the end...

I think that painted piece might be plastic - no, I’m not going out to check.

Okay, yes I am.

Okay, it seems to be metal but the bumper also appears to be three separate main pieces plus trim.

 

[ctechbob]

Correct...rear bumpers...but where's the end cap? It's still a full steel bumper to the end...

It's in 3 pieces that all bolt together.

It is kind of a complicated little bugger of an assembly to take off and put back together.

Not hard, just harder than it should be and is a lot easier with a little help.

 

[RedRocker]

I have a left side I would give you, but my right side got dinged too. I just replaced the whole thing with an ARB rear bumper.

Sponsored