The monkey took a doodoo on the seat unfortunately...Looks like you got a little sh!t on your passenger seat. And I don’t even want to know what that monkey is all about.
Hey Chris is that the leather armrest?So I found an armrest replacement from Ford. KB3Z-2106024-AA (Black). For those who were wondering how to remove the old one here is how the part arrives from the factory so that shows how it will come off. The frame and mount is integral to the arm rest. Ill comment on my replacement when I get time to install it.
My truck is a pretty basic 2019 XLT with the Ebony Cloth interior, so this arm rest is the black fake leather/vinyl. Ive never sat in a full leather Ranger to know of that part is different honestly. See picture. No fancy decorative stitching, only cheap fake leather.
Thanks
Install is done! Not too bad a job.So I found an armrest replacement from Ford. KB3Z-2106024-AA (Black). For those who were wondering how to remove the old one here is how the part arrives from the factory so that shows how it will come off. The frame and mount is integral to the arm rest. Ill comment on my replacement when I get time to install it.
has the replacement arm rest held up over time? or has it begun to fall apart like its predecessor?Install is done! Not too bad a job.
1) You have to pull the USB/120V outlet panel straight back. After squeezing the top. It has four of those white clips on the bottom.
2)Undo four 7mm hex head screws that bolt the armrest to the main center console(use a crescent wrench no room for a socket).
3)Pull the rear console cover straight back(just a little bit of tugging straight back). Rear console cover doesn't need to be removed all the way just the top of it enough to slide the arm rest off. It was a pain till I stopped being gentle.
4) Slide out the old armrest
5)Re Tighten 4 screws. And then pop it all back together.
Still good as new! I dont think it will last forever because it doesn't seem to be made any better. But its still perfect!
awesome, thanks for the follow up!
