What did you do to your Ranger today?

[AzScorpion]

If you want to publicly acknowledge your low T and ED the damper is the best way to come out…????

It's not like we're all sitting around drinking this? Well, at least not all of us. ?

Sponsored

 

[scarchild35]

Now you're talkin'! Everyone's welcome especially the holdouts. It makes sending the t-shirt that much sweeter. ?

Oh I'd be honored, haha.

 

[Dr. Zaius]

Shortened the bed rack rails that I recently installed to better fit my truck.

Removed 8.25 inches off of them.

Fits much better.

Also installed my Air Design fender vents.

Before

The factory vents are held on by adhesive on the rear edge and clips around the perimeter. The Air Design vents just use the 3M molding tape.

And the After pic

 

[MrBusses]

Installed a 12V plug in the bed. I used a ford male connector and a $8 12v plug from amazon. I had to Dremel the hole slightly bigger to get it to fit and I used some right angle spade connectors on the back otherwise it would hit the inner fender. I was originally going to use the top square hole but it wasn't deep enough, I still might move it to a lower position but my hole saws are at work. The pig tail cost me $25 with my employee discount and the out let was $8 on amazon. link for the plug https://a.co/d/dIMqtO3 I also attached the wiring diagram for the plug C243 is the connector under the truck and the connector that is needed.

 

[RedDakooter05]

Debated what to do about this

This f'ing truck lmao. Fantastic quality bumper to bumper.


Ah well.

 

[Synfulz]

I gave it a very thorough wipe down and cleaning everywhere. The wheelwells, suspension, under the hood, and of course body. As I am getting my 2nd oil change tomorrow. They do a thorough inspection on intake. So if all clean makes it easier to see I have no scratches, or damage.

 

[AzScorpion]

I gave it a very thorough wipe down and cleaning everywhere. The wheelwells, suspension, under the hood, and of course body. As I am getting my 2nd oil change tomorrow. They do a thorough inspection on intake. So if all clean makes it easier to see I have no scratches, or damage.

Pics? We need pictures! ?

I guess it's true that Mall Crawlers get dirty and need detailing too. ??

 

[RedDakooter05]

I gave it a very thorough wipe down and cleaning everywhere. The wheelwells, suspension, under the hood, and of course body. As I am getting my 2nd oil change tomorrow. They do a thorough inspection on intake. So if all clean makes it easier to see I have no scratches, or damage.

They care if someone has scratches on their intakes?

 

[Synfulz]

Pics? We need pictures! ?

I guess it's true that Mall Crawlers get dirty and need detailing too. ??

 

[AzScorpion]

And some here say I have OCD issues with my detailing.

 

[Tracy Bowman]

I guess I should at least get that, so I can be a part of the elite club. If they'll have me in it...

But, is that really what it’s called?

 

[KJRR]

And some here say I have OCD issues with my detailing.

Anyone who has seen under your hood or your engine cover knows better.

 

[TN Ranger]

So when I got my Westin winch tray I add the RC tow hook conversation to the bottom of the tray. Liked it bout was not too happy about the overhang. So I decided to modify the factory ones and istall them in the spaces provided for the tray. Also found some tow hooks from a F350 laying around so bolted them to the rear bumper supports for some rear recovery points. Found some cutting board material and cut me a tailgate table as well.

 

[Dr. Zaius]

What wheels are those?

They look really sharp

 

[Synfulz]

What wheels are those?

They look really sharp

AD Wheels

Sponsored