FirstRanger011
Active Member
- First Name
- Collin
- Joined
- Sep 21, 2020
- Threads
- 3
- Messages
- 40
- Reaction score
- 184
- Location
- Houston, Texas
- Vehicle(s)
- 2020 Ford Ranger XLT 4WD FX4
- Thread starter
- #1
Installed my Mountain Hatch this afternoon. Absolutely love it.
Took me about half an hour to install. Most of that was cutting away at the bed liner on the screws so I could screw them out to install. Does make the tailgate slightly heavier, but that’s not issue to me.
EDIT: In case any of you all have the bed liner too and decide to install this as well, just use a knife and cut a circle around the screw, then cut in, lift it, and rip. Took a few minutes to figure it out but after thats its easy.
Took me about half an hour to install. Most of that was cutting away at the bed liner on the screws so I could screw them out to install. Does make the tailgate slightly heavier, but that’s not issue to me.
EDIT: In case any of you all have the bed liner too and decide to install this as well, just use a knife and cut a circle around the screw, then cut in, lift it, and rip. Took a few minutes to figure it out but after thats its easy.
Sponsored
Last edited: