What did you do to your Ranger today?

[Big Blue]

Fog lights arriving sometime today...that'll be a good day putting those in!

Shouldn't be that bad. Just drop the Skid plate and you can get at them just fine. Loosen the back two bolts remove the front two and it slides right out. plenty of room to get at the fogs. That's how I did mine. No bumps or bruises.

Sponsored

 

[armoredpig]

Washed and maintained my ceramic!

 

[Augie81]

Washed and maintained my ceramic!

Looks great. ? back at you. ?

 

[FoD]

Shouldn't be that bad. Just drop the Skid plate and you can get at them just fine. Loosen the back two bolts remove the front two and it slides right out. plenty of room to get at the fogs. That's how I did mine. No bumps or bruises.

I'll let you know how it goes. Thx

 

[canigetadollar?]

Added smoke side markers, a little before/after

Do you have a link for these side markers? How'd they fit?

 

[Jbroke]

Do you have a link for these side markers? How'd they fit?

I’d say 99% good fit
https://www.ebay.com/itm/2019-2020-...e:Ford&hash=item2d0634a3a0:g:MIIAAOSwilpeaDWq

 

[jerrywin]

a little overlanding yesterday ...

 

[jerrywin]

a route between Alamosa and (basically) Pagosa Springs in Colorado.

 

[quangdog]

Just ticked past 5000 miles:

 

[slowmachine]

Installed Ford drop-in bed liner. Time for truck stuff.

 

[egilbe]

According to FedEx, I have my new ditch light mounts from @FordRangerLifts at home. So I have something to do this weekend before I start my vacation

 

[Lonewolf]

CoverKing Neosupreme cover installed, rear seat only. Very nice quality and fit. Not bunchy or weird around the edges. Would recommend.

Wow.. those look nice. Was it hard to install?
I just started to look for seat covers for my front.

 

[dmeyer302]

Wow.. those look nice. Was it hard to install?
I just started to look for seat covers for my front.

Not hard at all. Basically you drape it over the top and it velcros together at the bottom. It's a nice solid connection.

 

[FoD]

Switched out fog lights to yellow LED.

Shouldn't be that bad. Just drop the Skid plate and you can get at them just fine. Loosen the back two bolts remove the front two and it slides right out. plenty of room to get at the fogs. That's how I did mine. No bumps or bruises.

Dropping the plate was a good move, but area still a little tight for Bluto hands..

Biggest issue here was the new gasket being thicker than the Ford one, followed by light having to be inserted first , then wire harness connected. I think that all had to do with the size of the light itself.

First one took me about 45 minutes to figure out the steps and the other took 10 once I had it figured out.

BTW that bolt shaft the sticks through beneath the light housing is a real terror if your not looking up in there. LOL!!

 

[Truckee Bill]

Installed the CalTrend neoprene covers.

I installed the Ford neoprene seat covers but they don't fit as snug as I would have hoped. And I do have heated seats. No problem at all.

Sponsored