What did you do to your Ranger today?

[Danager]

OK - Nice...now I get it. Hopefully that was a picture you already had ;-)

So the module goes on that opening and the grommet is inside that opening going to the underside of the truck above frame level?

New photo. It’s okay though. The trim was still off and the module out until I can adjust the time delay on it. Then will wrap it in foam tape and tuck it away.


Correct on the placement & locations.

Sponsored

 

[GregP]

I installed some new Husky Liners?

Those look great! What is

I installed some new Husky Liners?

Those look great! What is your opinion of the retention clips? Ive got the Weather Tech mats and the retention clips are weak at best.

 

[DCPX]

They clipped in fine on the driver side.

The passenger side mat came with the holes to be clipped in but, the ranger doesn’t have anywhere to clip them though. It still lays in fine with no movement. I’m overall happy with the fit and look.

Honestly, I would just keep your weather techs for as long as possible if they work. These mats are just to expensive for a mediocre mod

 

[paval3]

Well, it was yesterday, not today... I took off the rear license plate frame with the bold white lettering with the dealership name and put on a plain black matte metal frame. Still have the very small black decal with the dealership name on the bottom left side of the tailgate, so I figure that's enough advertisement for them.

 

[Cabose-1]

Well, it was yesterday, not today... I took off the rear license plate frame with the bold white lettering with the dealership name and put on a plain black matte metal frame. Still have the very small black decal with the dealership name on the bottom left side of the tailgate, so I figure that's enough advertisement for them.

I took everything off day one. Even the little stickers they put on the car. Unless they pay me to keep it on.

 

[paval3]

I took everything off day one. Even the little stickers they put on the car. Unless they pay me to keep it on.

I don't know if I can get the decal off now ... it's been on since end of April 2021. Would I have to take a hair dryer to it to get it to peel off easily?

 

[Cabose-1]

I don't know if I can get the decal off now ... it's been on since end of April 2021. Would I have to take a hair dryer to it to get it to peel off easily?

I dont know. Mine was lettering and it just peeled right off

 

[Doc]

I don't know if I can get the decal off now ... it's been on since end of April 2021. Would I have to take a hair dryer to it to get it to peel off easily?

Spray it with WD-40, wait 15 minutes then hair dryer..

 

[Bob902]

I don't know if I can get the decal off now ... it's been on since end of April 2021. Would I have to take a hair dryer to it to get it to peel off easily?

try to just peel it first. If not, very light heat and it should come right off.

 

[UnregistredHypercam2]

KO2's installed and lookin real nice

 

[Bob902]

KO2's installed and lookin real nice

I have the same wheels. What size did you go with?

 

[JimInAllen]

Installed my GoRhino Black Chrome exhaust tip!

 

[UnregistredHypercam2]

I have the same wheels. What size did you go with?

265/65/18

 

[Trash Panda]

Took a little photoshoot of the Danger Ranger after washing the other day. ?

It’s looking CLEAN. (Figuratively & Literally)

•Adam’s Polishes CS3 & Graphene Tire Shine for those wondering.

 

[Jrigsby2000]

Got the BDS 2" level kit along with the Fuel Rebel D680 17X9 wheels and 285/70R17 BFG KO2's installed today and am very happy with how it came out!

I have a 2 1/2” RC level on mine with 265/70/17. Do the 285s scrub at all?

Sponsored