They fit. No alterations needed.
Awesome. Which bds kit do you have the cheaper or more expensive one. I assume it's a 6 inch kit.They fit. No alterations needed.
Tremor's don't really have a 'lift' per say. However, they have upgraded leaf springs and better fox coils up front.
Yes, I got the cheaper one with spacers. Ain't nobody got money for that expensive shit. My setup is a bit unique, I have a spacer stack up front. 3" from fordrangerlifts.com and then the BDS 6" spacer. All that on top of the tremor coil which gives about a 1" lift from FX4.
I talked to the engineer at BDS and he said they work. I'm gonna go 3.5 pretty soon.
I hear ya about the cost. Did u install the lifYes, I got the cheaper one with spacers. Ain't nobody got money for that expensive shit. My setup is a bit unique, I have a spacer stack up front. 3" from fordrangerlifts.com and then the BDS 6" spacer. All that on top of the tremor coil which gives about a 1" lift from FX4.
I'm totaled around 9-10 inches up front while the rear is up 6" from stock. I'm leaning back a little bit, the front is about an inch taller than the rear. I feel like this corrects some of the slanted body lines and gives the truck a much bigger look.
Had a shop do it
That helps immensely. Thank you so much. I have not been able to get an answer from anyone. You rock dude.
Your welcome. I myself could not get answers so I researched, called and finally come up with an answer after about a
That's incorrect, aluminum spindles were used 2019 to 2020 then most 2021+ had cast iron. The Tremor isn't different.
Any lift kit should work on a tremor, as the only difference in parts between a tremor and non tremor is the coilovers, leaf springs and rear shocks.
Thanks dude for all of the info. I appreciate it.
I'm only running 33's plans to do 34's or 35's once change front and rear bumpers. Some other members are rocking 35's though, general consensus seems to be the truck does well enough but regearing really helps it feel closer to stock.
Correct, unless BDS finally modified it for cast iron spindles. I looked into it with my 2021 FX4, and they only fit aluminum spindles I wanted the 3.5 lift. I talked to them many times, kept saying we were working on it. Then the Bronco came out and I think all resources went to that. Got tired of waiting so I went with the SVC billet UCA and Tie Rods could not be happier with them.
