Leveling kits, what is the actual thickness of the blocks.?

[TNFFRNGR]

Hello!
Just bought a 21 tremor love the trucks performance but the stance straight up looks like a 1980s camaro with the air shocks ladder bars and M/T 60s out back.
I feel like I should have a mullet, coors silver bullets and acid wash jeans go along with it
My question is has anyone ever actually measured the thickness of the 1" and 2" leveling blocks for the the front? I have set but I don't want to install them if they are too thick.
Will the 2" blocks for a regular ranger work on the tremor?
Thanks in advance

Sponsored

 

[LB'sTremor]

It's 1:2 ratio so a 1/2" spacer will get you 1" of lift
Lots of users have put 1" and 2" lifts on Tremors

And yeah kinda fond of those Camaro's and silver bullets

LB

 

[TNFFRNGR]

Thanks for replying. Same ratio as on my nissans too.
Prob gonna send these back as they claimed 2", but the blocks measure almost 1 1/4" thick.

 

[Colo_Ranger]

It's 1:2 ratio so a 1/2" spacer will get you 1" of lift
Lots of users have put 1" and 2" lifts on Tremors

And yeah kinda fond of those Camaro's and silver bullets

LB

This is the answer.

Thanks for replying. Same ratio as on my nissans too.
Prob gonna send these back as they claimed 2", but the blocks measure almost 1 1/4" thick.

sounds like a 2.5" lift.

 

[Jason B]

On my '26 FX4, 2.7, the MotFab 2 1/2" lift blocks were 1 1/2" thick and resulted in only about 2" lift.
yeah, quick mafs.

Sponsored