petulantskeptic
Well-Known Member
- Joined
- May 26, 2019
- Threads
- 1
- Messages
- 48
- Reaction score
- 42
- Location
- Washington
- Vehicle(s)
- 2019 Ranger Super Crew Lariat
There's no CEL.So to everyone that mentions that you get a code when you change the setting. Where does the code show up? Does it cause a CEL? Does it re occur at every start up? Is it always there? Do you need to have your programmer attached to see it? If you change the setting back to factory does the code go away?
I would like to change mine but I don't want to see any messages on normal operation. Thanks.
It shows up in the DTC section of FORScan. It goes away when you change 726-12-01 back to its default value.
Sponsored