Eibach shocks

[jkc-007]

Installed Eibach's on my Ranger yesterday set at 1.5". Much improve ride!

it looks like you set the front to 1.5 but what did you set the rears at?

Sponsored

 

[Bob902]

it looks like you set the front to 1.5 but what did you set the rears at?

There isn’t any adjustment for the rear shocks. The front coil overs can be adjusted.

 

[jkc-007]

There isn’t any adjustment for the rear shocks. The front coil overs can be adjusted.

thanks, but their website says,

• Rear Raise: 0-1.50 Inches

what does that mean?

 

[Bob902]

thanks, but their website says,

• Rear Raise: 0-1.50 Inches

what does that mean?

It will support the rear being up to 1 1/2 inches higher than factory. You can raise the rear by using lift blocks or changing out your leaf springs.

 

[Racket]

It will support the rear being up to 1 1/2 inches higher than factory. You can raise the rear by using lift blocks or changing out your leaf springs.

Or longer shackles. I really don't know if blocks or shackles are that good for street driven trucks but those of us who switched to multileafs (mine came from the UK from a seller taking them off new trucks to swap for air bags) get around a half inch lift in the rear. I put my front Eibachs halfway up - I believe that was 1 1/4 inch. It pre-loads the spring and I felt it was the way to go to get most of the rake out and improve the ride. The best initial improvement in ride was the rear shocks even though that didn't change the height. Somewhere I have pictures...

 

[jkc-007]

It will support the rear being up to 1 1/2 inches higher than factory. You can raise the rear by using lift blocks or changing out your leaf springs.

Oh i see, thanks!

Sponsored