BAKFlip MX4 Installed with Line-X bedliner

[LifeisaBeach]

Does anyone have any experience installing a BAKFlip MX4 with Line-X bedliner. Do you need to drill into the bedliner to install the tonneau cover? Is this a difficult install and are their companies who will install for you?

Sponsored

 

[puckdodger]

I don't think there is any drilling. My truck was a demo and it was already on and Linuxed. I took it off a while back and everything just clamped in place.

 

[GregP]

I have both the MX4 & Line-X. The local Line-X dealer for me was also a Backflip distributor and they would have installed both if I wanted. There is no “drilling” required, but if the Line-X came first you may need to clear some holes for the mounting brackets.

 

[LifeisaBeach]

I have both the MX4 & Line-X. The local Line-X dealer for me was also a Backflip distributor and they would have installed both if I wanted. There is no “drilling” required, but if the Line-X came first you may need to clear some holes for the mounting brackets.

You are a gentleman and a scholar! Thank you for the most helpful reply!!!!

 

[mustang marty]

Dealer did the Linex and then I decided on the cover a couple of weeks later . The dealer did it too , not too difficult because after 3 coffees they were done . Did not see any drilling .

 

[AzureRanger]

I had an MX4 on my F150 with a spray in liner. The only drilling needed was through the removable plastic "plugs" at the front of the bed to route the drain tubes.

 

[Jrel209]

Yes, factory linex, had to drill and redo the threads with a drill tap bit.

 

[Dereku]

I have the gator cover which back flip makes for them. Clamps on the the ever so flimsy bed rail lip and doesn't touch the liner. But solid product overall.

Sponsored