What did you receive in the mail today for your Ranger?

[DonovanJM]

Got a single bike tailgate pad. I think I want to find something to put under the strap that goes below the tailgate. Looks like it might leave a mark. Other than that it looks like it will work like a champ!

Sponsored

 

[DukeCanBuildit]

I normally am not an influencer.
But with the new G6 ranger and the type C connection I wanted to see what was on the market and got this for under 10 bucks today.

Two type C Plugs,, and the conver still goes down. Upgrading the wife’s iphone8 this weekend.

.

Hey Mike - that’s sharp - have a link?

 

[DonovanJM]

Got a set of tie downs to replace the deleted ones. Actually got them yesterday just didn't know it. Got them from a fellow forum member too.

 

[Scottopia]

Did not order, but these showed up in the truck overnight !

?

 

[RedDakooter05]

Got some misc projects this will be used for.
Front inner fender painting(where the lack of rubber flaps are)
Rocker panel
Ect.

 

[lukdeg]

Got pissed at my previous upfitter switch remote last week( no dimming option and a blown relay) so i got this on amazon, auxbeam rip off, feel solid, metal instead of plastic, will install tomorrow or Tuesday.

 

[P-38Ranger]

Hey Mike - that’s sharp - have a link?

Best I can do. USB C Car Charger, 40W PD 3.0 Smallest Dual Type C Car Powe

 

[DukeCanBuildit]

Best I can do. USB C Car Charger, 40W PD 3.0 Smallest Dual Type C Car Powe

Thanks - it was enough information to find it. ?

 

[jflogerzi]

i

not really for my ranger, but ranger related. i paid around $350 on my 9+yo raptor last july, another $450 or so last september on the ranger, and now this due by the end of july. gots to pay to play in the great state of kansas, apparently

paid 545$ ish for truck in the great state of CA?

 

[Canuckian]

Finally cracked and ordered a rack. Arrived recently (not quite “today”). Sadly missing the t-nuts to mount the front windscreen. Installing soon.

 

[JACKSMYDOG]

Finally cracked and ordered a rack. Arrived recently (not quite “today”). Sadly missing the t-nuts to mount the front windscreen. Installing soon.

If you have a swear jar, throw $20 in it before you get started

If I were doing it again, I'd order some extra plus nuts and have them in hand before starting. The silver riv nuts they supply were crap.

 

[Canuckian]

If you have a swear jar, throw $20 in it before you get started

If I were doing it again, I'd order some extra plus nuts and have them in hand before starting. The silver riv nuts they supply were crap.

thanks for the advice. I have not heard good things about the install. I already have a deposit on the sweat jar. In addition to forgetting the t-nuts, they gave me the wrong length cross bar for under the wind screen.

 

[JACKSMYDOG]

thanks for the advice. I have not heard good things about the install. I already have a deposit on the sweat jar. In addition to forgetting the t-nuts, they gave me the wrong length cross bar for under the wind screen.

Most of the install isn't too bad, just the plusnuts, especially the aluminum ones are aggregating.

You'll need to have some sealant on hand, it doesn't come in the kit. I can't remember exactly what I used, but something like GOOP Automotive, Permatex gasket maker, or similar.

Also a 1/4x20 die thread cutter to clean up the threads on the plus nuts install bolt. If you don't have one, a few spare 1/4x20 bolts will do.

The bright side is, once it's on, it is awesome.

Good luck!

 

[Ninong]

Got this snorkel scoop from Velossa in the mail yesterday and already installed it.

 

[Bsenecal]

Got this snorkel scoop from Velossa in the mail yesterday and already installed it.

Great product, you should see a slight gas mileage increase, I noticed.3-.5 MPG increase after installing one.
Brian

Sponsored