What did you do to your Ranger today?

[ControlNode]

I decided that for my use of the truck (towing and such) a camper shell was going to be too much weight, and likely need frequent removal. But if I'm going to a race where I'm towing the heavier car I then loose the camper shell for sleeping in. So, 15lb tent is in. Installed here with the tonneau cover folded and propped up. The extra space from the tailgate is really nice, remember I'm 6' and have slept in that 5' bed under the tonneau cover, still can if I don't want to set up the tent but now it's roomy enough for my wife and I to sleep in it. And yes, the step stool is part of the kit for my wife, but I'll use it to since it is there.

I will likely remove the cover when I go to actually use this tent though. It's only 2 coax nuts to remove the antenna leads from the pass-thru coupler and a couple thump screws and the tonneau cover is off. I'll likely put the roof rack back on the truck so I have a place to set the tonneau cover while it's off the bed so it's not on the ground.

Already thinking about making a shelf for inside the tent that uses magnets to secure to the bed through the tent's flooring fabric.

Sponsored

 

[AzScorpion]

I'm sure everyone's parents have a baby picture of when you were born, naked getting your first bath? Well, here's mine.

You sick perverts it's my new Tremor! ??

 

[IdahoRanger]

Your fender is misaligned.?

 

[RedDakooter05]

Need s fender damper.

 

[Chris M]

Your fender is misaligned.?

And the Tremor stickers are crooked.
But I'm not judging.
?

 

[Scott_Anderson_]

-Washed, clayed, and waxed
- Tactilian flags
- Red valve caps

 

[AzScorpion]

And the Tremor stickers are crooked.
But I'm not judging.
?

Because of all you guys that's one of the first things I checked at the dealership.

They're straight.?

 

[ControlNode]

Because of all you guys that's one of the first things I checked at the dealership.

They're straight.?

But what about after you level it?

 

[Chris M]

But what about after you level it?

BINGO!

 

[AzScorpion]

But what about after you level it?

The Tremor comes leveled from the factory.

 

[AzScorpion]

I'm sure everyone's parents have a baby picture of when you were born, naked getting your first bath? Well, here's mine.

You sick perverts it's my new Tremor! ??

I was going to wait until tomorrow to Graphene it but I just had to do it today. So 2 coats of Graphene and 1 coat of Graphene detailer and she's done. ?

I've always liked white but one thing is after all the hard work it doesn't pop like the darker colors do. It's more noticeable when the sun is setting but there's still a really nice shine which you can see by the hood. Tomorrow I'll do the interior with the 303 Aerospace Protectant then start putting all the accessories on it.

 

[yamahaSHO]

Swapped on a Tremor grille, after swapping the black border trim from my original grille, painted the gloss black to flat black, and painted the Ford emblem.

 

[MrBusses]

Installed a set of Bronco black diamond wheels and tires. My original plan was to keep these one for off road use only but after seeing them on the truck I really like it. Now I gotta break down my oem wheels and transfer the sensors over. These wheels were take offs from my dealership only cost $250 for all 4 wheels and tires. I used the Bronco center caps and just spray painted them black to hide the Bronco logo.

 

[BS67]

I'm sure everyone's parents have a baby picture of when you were born, naked getting your first bath? Well, here's mine.

You sick perverts it's my new Tremor! ??

Bumper looks a bit higher on driver's side than passenger............

 

[Msfitoy]

I fixed the dreaded low speed shutter/stumble!

Sponsored