Tremor Upgrade UCA????

[Aonarch]

I am considering swapping back to stock. I don't think I need these for any alignment correction, and I am skeptical they give much if any more travel, and I don't love the squeak. Gonna give some more time, but I am considering.

No squeak for me.

I assume you greased them?

Sponsored

 

[gwhalin]

No squeak for me.

I assume you greased them?

Yep couple of times.

 

[Aonarch]

Yep couple of times.

Torqued to spec?

The long bolt is around 120 ft lbs, the upper ball joint is around 60 ft lbs

 

[gwhalin]

Torqued to spec?

The long bolt is around 120 ft lbs, the upper ball joint is around 60 ft lbs

Yep and torqued on the ground. I just think these poly bushings squeak a lot. They aren’t horrible after the most recent round of grease so will see how long that lasts.

 

[Dr3wDrop]

Yep and torqued on the ground. I just think these poly bushings squeak a lot. They aren’t horrible after the most recent round of grease so will see how long that lasts.

What grease are you using?

 

[gwhalin]

What grease are you using?

Super Lube synthetic. What is recommended by Icon

 

[Dr3wDrop]

Super Lube synthetic. What is recommended by Icon

I did the Lucas Oil Red & Tacky. Mine were only installed last weekend but I have not had any noise.

 

[gwhalin]

I don’t think uncommon for poly bushings to squeak. Always been my expectations of them. I am gonna try the Teflon tape trick I saw someone mention on YouTube next time I need to grease these.

 

[Wes.harris07]

I’m running the APG Mid-Runner Kit with their UCA on my Tremor. Good stuff.

How is that mid runner kit? I’ve been looking at that.

Sponsored