AZ_Stryd3r
Active Member
- First Name
- Mik
- Joined
- Mar 24, 2022
- Threads
- 6
- Messages
- 29
- Reaction score
- 50
- Location
- Chandler, AZ
- Vehicle(s)
- 2021 Ranger XTL FX4
- Thread starter
- #1
Not for the feint of heart - but I think it turned out well.
Start with cutting the switch case and trim the round part that holds the rotary dial:
Remove and cut up the mirror switch above the pc board and the screw blank in the facia above - only works if you do NOT have the mirror fold in option:
Drill, file, carve out the switch hole- and hack out a bit for the light:
**Removal Note - Start with the facia removal on the Right. There are a couple of those plastic clips ford engineers fell in love with, and 2 tabs on the left that release as you swing the facia towards the door.
Could have been a bit cleaner. Cut a bit, test fit. Cut a bit more, test fit... etc..
Start with cutting the switch case and trim the round part that holds the rotary dial:
Remove and cut up the mirror switch above the pc board and the screw blank in the facia above - only works if you do NOT have the mirror fold in option:
Drill, file, carve out the switch hole- and hack out a bit for the light:
**Removal Note - Start with the facia removal on the Right. There are a couple of those plastic clips ford engineers fell in love with, and 2 tabs on the left that release as you swing the facia towards the door.
Could have been a bit cleaner. Cut a bit, test fit. Cut a bit more, test fit... etc..
Sponsored
Last edited: