Metal tail lights guards

[RDJTX]

anyone see tail light guards for our trucks yet?

I just did a search .. nothing later than 2021 was found

Sponsored

 

[Msfitoy]

I just did a search .. nothing later than 2021 was found

So you found one for 2019?

 

[RDJTX]

So you found one for 2019?

to be honest ... not 100% sure since they all seem to say yes till you get to their web site and they say no. ran into a few of them ...

this guy says his will fit 2016 and up. I would check with him to be sure and to check his return policy before putting in a order. He does have 11K+ sales and 100 feed back so that says a lot
https://www.ebay.com/itm/3938845040...A3sqSO2FtiOxzkQo7lrY1Kh9SeXrHQLhoCoO0QAvD_BwE

 

[LaBalbe]

Reviving this old thread, because now that Thing 1 has a learner's permit and I've just had to replace the tail light that my sister smashed, I'm seriously considering a little extra protection. The eBay link above is still active, but it seems more cosmetic than anything else.

 

[TxOTRRanger]

Reviving this old thread, because now that Thing 1 has a learner's permit and I've just had to replace the tail light that my sister smashed, I'm seriously considering a little extra protection. The eBay link above is still active, but it seems more cosmetic than anything else.

You're right. That doesn't look like it would offer any real protection.

 

[PltFX4]

IDK....... Mine held up fairly well and it was under water for a bit as well. LMAO... Yeah I was in anywhere off road USA... Bawwaaa

Are saying you did not see that coming??? Or you did and it didn't matter??

 

[Rp930]

You mean the guards that usually rust to death after a couple of years?

 

[ControlNode]

As stated before, they likely never became an option as they are likely only compatible with Rangers that don't have BLIS sensors in the lights, so it's likely too small of a market to justify making them. As for the ebay link to the ROW Ranger trim/cover. Don't expect that to fit the US market Ranger, we didn't get the same bed or tail lights as the ROW Rangers.

 

[DukeCanBuildit]

Reviving this old thread, because now that Thing 1 has a learner's permit and I've just had to replace the tail light that my sister smashed, I'm seriously considering a little extra protection. The eBay link above is still active, but it seems more cosmetic than anything else.

I’ve seen her skeleton down my backyard sled run - you need something along these lines...

 

[LaBalbe]

I’ve seen her skeleton down my backyard sled run - you need something along these lines...

You've got a point. Maybe I should draw some inspiration from this:

Or, I could go this route; a lot cheaper, but not quite as much protection:

 

[TxOTRRanger]

You've got a point. Maybe I should draw some inspiration from this:

Or, I could go this route; a lot cheaper, but not quite as much protection:

This...................
Maybe?

 

[LaBalbe]

This...................
Maybe?

The Tango & Cash mobile, where Tesla got the inspiration for they Cybertruck windshield!

 

[TxOTRRanger]

The Tango & Cash mobile, where Tesla got the inspiration for they Cybertruck windshield!

Yeah, but I would drive the Tango & Cash mobile and use the Cybertruck for a jump ramp!

 

[LaBalbe]

Hopefully by the time she's got her full licence, my truck won't look like this

 

[TxOTRRanger]

Hopefully by the time she's got her full licence, my truck won't look like this

Let's hope not. Prayers and all of the Good luck I can send your way are with you buddy.

Sponsored