Dang! I did not know that aeroforce pod existed... I am getting one hand made from HN Customs in Australia.
I just learned about a couple weeks ago. A member of my Facebook group was involved in the process.
That is because the factory settings for the electronic throttle controller. Everyone should be familiar with that delay and flooring the pedal and the truck actually taking off.Added a new page layout to the idash.
1) Horsepower from the ECU
2) Torque calculated by the ECU
3) Fuel Rail Pressure
4) Accelerator Pedal Percentage (assume this translates to WOT).
The funny thing is my foot was to the floor for a good second so category #4 saying the throttle was only 77% open was enlightening.
That's a slick setup, definitely on my list of "I have $500 bucks to blow" mods.
I'm surprised it wasn't lower... In our litigious society, it falls on the manufacturer to protect people from themselves. I'm surprised pressing the throttle to the floor doesn't cut power because no one could possibly need to go full throttle with 327 horsepower. [/sarcasm]
How did the stock venf come out was trying to pop it off wasn't moving at all? Seems like it was part of the dash.Installed my HN Customs gauge pod mount this afternoon. Fit and finish of this hand made piece is incredible. 10/10 and worth the wait to get it.
Here are some pics of the install. Had to drill a hole in the dash to route the wires to the OBD port. Took my time and it came out great.
Awesome thank you!
