JCR Offroad Molle Panels

[amaxwell]

Today I added the Molle Panels from JCR Offroad. Super quick and easy to install. Adding an admin pouch to the driver side to just hold some small loose things that normally sit in the center tray.

Sponsored

 

[Dereku]

What a great spot for a gun! At times they can get uncomfortable to sit with. Look pretty good too. How much did they run you?

 

[amaxwell]

What a great spot for a gun! At times they can get uncomfortable to sit with. Look pretty good too. How much did they run you?

I think when I picked em up they were $129.99 right now they are on sale https://www.jcroffroad.com/product/RG4DP.html

The center console panel has a dedicated spot for a holster

I have them already as well but I am in the middle of wiring my Switch panel so I will put them on once I have my trim pieces snapped back in

 

[Dereku]

Cool. I just looked them up. I had to navigate away from the page. Cant spend money....

 

[Colo_Ranger]

I've been looking at these. Makes use of dead space, but I don't know what I would hang on them.

 

[amaxwell]

I've been looking at these. Makes use of dead space, but I don't know what I would hang on them.

On my driver's side, I just have an Admin panel with a pen, pocket knife, fire starter, and some travel ibuprofen. Just lose things that were in my center console and armrest

 

[OFC Ranger]

On my driver's side, I just have an Admin panel with a pen, pocket knife, fire starter, and some travel ibuprofen. Just lose things that were in my center console and armrest

Wouldn't that same pouch have just fit in the center armrest console?

I couldn't do the driver side panel anyhow. I'm a pretty big guy and my knee goes in that area. I guess I sit in the what they term "mansplaining" position when I sit down.

 

[amaxwell]

Wouldn't that same pouch have just fit in the center armrest console?

I couldn't do the driver side panel anyhow. I'm a pretty big guy and my knee goes in that area. I guess I sit in the what they term "mansplaining" position when I sit down.

It could but I carry my DSLR with me in the center console and it takes up most of the space in there

 

[MountainGoat]

Both the centers and door panels seem like a deal, being sold in pairs. Now if only someone would 3d print a attachment tray for holding my chicken tendies and sauce cups I'd be all set.

 

[amaxwell]

Both the centers and door panels seem like a deal, being sold in pairs. Now if only someone would 3d print a attachment tray for holding my chicken tendies and sauce cups I'd be all set.

Custom chicken tendie holder is genius

 

[TICKLE ZOMBIE]

Looks great! I am tempted but at the same time I don’t want to drill in the door. ?

 

[D Fresh]

I've been looking at these. Makes use of dead space, but I don't know what I would hang on them.

Buy a set for both of us and I'll help you figure it out!

 

[Colo_Ranger]

Buy a set for both of us and I'll help you figure it out!

 

[Colo_Ranger]

Looks great! I am tempted but at the same time I don’t want to drill in the door. ?

the first hole is the hardest. Gets easier from there…

 

[TICKLE ZOMBIE]

I really should have been honest and say that I’m prone to not drilling straight and fear it’ll end up crooked. ?
Might have my mechanic do it. ??

the first hole is the hardest. Gets easier from there…

Sponsored