What did you do to your Ranger today?

[alan0614]

Installed Bora 1” spacers, gave it a test drive and a bath.

Sponsored

 

[tentspast]

Installed ditch light brackets and ditch lights as well as an Auxbeam 6 gang switch panel to tie everything together. The ditch lights are cheap Lightfox ones but surprisingly good - will probably swap them for something better later on though as I doubt they'll last too long. It was a rather eventful install, the power steering suddenly gave out this morning - turns out I had somehow loosened a fused power cable going to the battery which happened to be for the power steering module. After a lot of panicking I found the problem and all was well?‍?
The switch panel is actually really well made, but was a little disappointed that it doesn't have an earth busbar built in to the fusebox - it's power distribution only so you still have to earth all your accessories somehow.

 

[tm1506]

Installed the Ford Performance Grill and TVD grill letters.

 

[TVRangerSTX]

Installed the Ford Performance Grill and TVD grill letters.

Looks like 300 hp now!

 

[tm1506]

Looks like 300 hp now!

375 hp with E85!

 

[KNI]

Forgot the eberspracher heater on while shopping. Came back some time later to nice 60-80'C car (warms the coolant to 80'C and runs water pump & heat exchanger to cabin)

 

[Jhbryaniv]

Forgot the eberspracher heater on while shopping. Came back some time later to nice 60-80'C car (warms the coolant to 80'C and runs water pump & heat exchanger to cabin)

Now that looks way more betterer than an engine block heater...

 

[Strobes]

Oil change/ tire rotation - 20,569 miles on my 2020 XLT (16,000 all me). Haven’t made any changes for months and that itch really wants to be scratched but I’m gonna wait until my reward dollars come back from 2022 on my Costco credit card. So far it’s almost $600.

Gonna get new speakers and amp, I can’t stand the lack of power in these stock ones.

Hope you all are well, here’s a picture of the babe.

 

[MadDad89]

Blew out the water lines on the vineyard today.

 

[Strobes]

Nice topper!!

Ya I’ve had it about a year now and I still really dig it!

Oh, and Hi, @Tracy Bowman ?

 

[OFC Ranger]

Finished up my new front end setup. Minus fogs, lamin-x sent me wrong amber fog light covers, so waiting on those.

And then I finished tearing down the bed rack and roof platform for some maintenance, upgrades, and a fresh coat of paint. Looks so naked now.

I also need to start fabbing up some relocation brackets for my middle front sensors.

 

[tentspast]

Installed 1 inch wheel spacers all around. Looks a little bit less spindly now.

+ Gratuitous driveway shot

 

[Tracy Bowman]

Ya I’ve had it about a year now and I still really dig it!

Oh, and Hi, @Tracy Bowman ?

Hello, @Strobes!!!

 

[subquark]

I had some blue 3m reflective tape that seemed to be close match to my Ford blue hooks. So I added it to my grill and side vents.

I like this blue reflective tape and it looks nice like this.

Has anyone added rear reflective tape to their rear bumper?

I searched but could only find this post.

I'm thinking of getting this to make my truck more visible when parked on the street at home. I don't care about the ugliness, I'm all about max usability and safety.

https://www.tapedealer.com/product/by-the-foot-oralite-v98-chevron-reflective-rolls/41

I'll probably add red & white reflective tape to the side steps for side visibility and may even add some to the inside of the doors for open doors if on the side of the road. And I'll likely add the red/lime chevron to the front bumper as well. LOL - wear your sunglasses at night! =D

Visualization on the new @AzScorpion-suggested Soupie II dump truck front end:

 

[puckdodger]

Fresh engine air filter and cabin air filter. Wow, they were disgusting after 25000kms

Sponsored