What did you do to your Ranger today?

[HTX1811]

Once again took the new fishing buggy (the Ranger) to my fishing spot and caught a few. Then stopped at the dealership and picked up the 4x4/Terrain Mode selector knob. Looks like I have some FORScan to do tonight.

Sponsored

 

[TVRangerSTX]

Once again took the new fishing buggy (the Ranger) to my fishing spot and caught a few. Then stopped at the dealership and picked up the 4x4/Terrain Mode selector knob. Looks like I have some FORScan to do tonight.

You must have one fishy-smelling Ranger!????

 

[HTX1811]

It does get hosed down after each trip which fortunately the last two weeks has been several times.

 

[HTX1811]

Could not wait until tonight. 10 minutes and I now have this.

 

[Bsenecal]

Could not wait until tonight. 10 minutes and I know have this.

Looks great I assume there is a plug just under the plastic?

 

[BannonJr]

Finally.. my smoke marker lights came in

 

[Jbroke]

Finally.. my smoke marker lights came in

Link for that? Looks nice!

 

[BannonJr]

Here ya go mate..

https://www.ebay.ca/itm/FOR-2019-20...1?pageci=b7ac1556-ca91-490b-bfa4-022230d803a9

 

[landiscarrier]

Door sill protectors.

guess I should have cleaned them and my floor mats before the pic! Haha.

 

[Jbroke]

Here ya go mate..

https://www.ebay.ca/itm/FOR-2019-20...1?pageci=b7ac1556-ca91-490b-bfa4-022230d803a9

pretty straight forward/easy installation?

 

[Tim H.]

Door sill protectors.

guess I should have cleaned them and my floor mats before the pic! Haha.

No way...It’s a truck!

 

[FoD]

No way...It’s a truck!

Unless it has valet tailgate service installed!!

 

[BannonJr]

Oh yah...2 min...reach behind ...like squeeze your hand through the panel...unclip n push... disconnect...connect new ones and put it back

 

[daniel3507]

Enjoying some time at Buffalo National River. Not getting to do as much off road exploring as I would like but enjoying the time with family

 

[HTX1811]

Looks great I assume there is a plug just under the plastic?

The knob pops out but you have to pry the piece of plastic it sits in then press in four prongs on the underside of the knob. Pretty sure if you try to pry the knob out you will destroy stuff. The pic of the knob is the non TM knob so don't use that as a part number. Both are identical except for the TM button.

Not a pic of mine but this shows the plastic piece that you pry up. Very simple.

Sponsored