Can a Ranger be tuned to Focus RS power and torque specs?

[HighCaliberMitch]

They share the same engine, and as far as I can tell, the same turbo, as well.

Is this engine capable of achieving the 350/350 numbers of the RS?

The only parts I haven't seen in the wild, for the Ranger, is an intercooler.

Sponsored

 

[808matt]

https://www.ranger5g.com/forum/threads/levels-performance-upgraded-intercooler.3874/

 

[Hounddog409]

They share the same engine, and as far as I can tell, the same turbo, as well.

Is this engine capable of achieving the 350/350 numbers of the RS?

The only parts I haven't seen in the wild, for the Ranger, is an intercooler.

It is not the same engine.

But a basic tune willl get you to 400lb ft of torque.

 

[Dokkenmire]

My weak preprogrammed 91 octane tune with no other mods probably has me close to 300hp and 325 torque at the wheels. Couple bolt ons and a real tune will easily make way more power.

 

[HighCaliberMitch]

What is different about it?

 

[Doc]

It is not the same engine.

But a basic tune willl get you to 400lb ft of torque.

The motor is supposed to be an upgrade of the Valencia RS motor with a different head design to prevent blowing headgaskets.
My wife’s mustang has that motor also , 2020 HPP Ecoboost 300 HP and 350 crank torque ( bigger turbo )my friend just tuned his Ecoboost ( which he has fabricated into a Beamer) in the 342/ 460 torque range , my conservative tuned stock ranger has 388 lb/ ft torque at the rear wheels. I will try to pull up his Dyno results.
Regards
Doc

 

[Doc]

I will post my Dyno results again so the op can view... couldn’t get an accurate hp reading as it was 110 degrees in the Dyno room that day...torque is correct...Regards

 

[Doc]

Ok , here’s my friends stock , pre 2019 2.3 ecoboost Dyno with just bolt ons 463 lb/ft torque Regards

 

[Doc]

They share the same engine, and as far as I can tell, the same turbo, as well.

Is this engine capable of achieving the 350/350 numbers of the RS?

The only parts I haven't seen in the wild, for the Ranger, is an intercooler.

There are intercoolers available. Try Levels Performance..
Regards

 

[HighCaliberMitch]

The motor is supposed to be an upgrade of the Valencia RS motor with a different head design to prevent blowing headgaskets.
My wife’s mustang has that motor also , 2020 HPP Ecoboost 300 HP and 350 crank torque ( bigger turbo )my friend just tuned his Ecoboost ( which he has fabricated into a Beamer) in the 342/ 460 torque range , my conservative tuned stock ranger has 388 lb/ ft torque at the rear wheels. I will try to pull up his Dyno results.
Regards
Doc

388 is nothing to scoff at. What the mpg on that?

 

[Doc]

388 is nothing to scoff at. What the mpg on that?

21.9 sport mode only consistent..
Regards
Doc

 

[treimche]

388 is nothing to scoff at. What the mpg on that?

This made me giggle. You don't do high HP and TQ tunes if you're super concerned about gas mileage.

 

[Doc]

My weak preprogrammed 91 octane tune with no other mods probably has me close to 300hp and 325 torque at the wheels. Couple bolt ons and a real tune will easily make way more power.

What tune do you have ?......(you can pm me your location)
Regards

 

[HighCaliberMitch]

This made me giggle. You don't do high HP and TQ tunes if you're super concerned about gas mileage.

In know, but being quasi concerned means I'm somewhat interested in numbers.

 

[Dr. Zaius]

I will post my Dyno results again so the op can view... couldn’t get an accurate hp reading as it was 110 degrees in the Dyno room that day...torque is correct...Regards

So that's roughly 338HP and 455TQ figuring 15% driveline losses.

Sponsored