You can find it on Ebay...mine's $210 but I've since seen $208 and make me an offer so you should be able to do better...
I got them from RealTruck.com. I’m pretty sure they make them for the SuperCab. Make sure you call them. I was able to get $30 off the already sale price, and free shipping.
No, it doesn’t give any dimensions like that. But sighting down the side of my truck, I measured and it sticks out about 1-1/4” beyond the crease in the door that sticks out the most. Looks like it sticks out about as much as the top of the rear fender. The bottom of the step is 11-1/2” above the ground. I have a 2-1/2” leveling kit on my truck so the front and rear step are the same height above the ground. I hope this makes sense and is helpful to you.
Where did you get your Raptor grille? I’ve looked around and can’t tell what will fit, and no too thrilled about buying from China.
You know it's hard to say now that I can see boost numbers I can actually see how much I lose when I get off the gas and then get back on the gas. it's supposed to even out the boost pressure and hold this longer so if you let the gas up and then hit it there's no turbo lag. Well I can't say there's no turbo lag but it's a lot less than stock. When you look at the stock parts to replace it they look so flimsy. Mercedes-Benz and Volvo and Ford use the same part. It's actually a Mercedes-Benz part I think if you find one for Mercedes or a Volvo it's it should fit in the Ford. Would I pay $139 for it? no but for 20 bucks well worth it. Hopefully AliExpress will get some more in
Thanks, it does. I was mostly wondering if it would stick out enough to protect the door from possible dings in parking lots
I had to remove my tonneau cover and buy a seal for the right rear wheel housing. I have double seals on the tailgate. It's important to be able to keep my bed dry when I have to do a gig in the rain. Thankfully that doesn't happen too often as I retired from that stuff
Not that wet at all. The right wheel well had water on it. So I uninstalled the right side of the tonneau cover I bought a small seal, and installed it between the Low Pro and the truck rails. The car wash is where I always see if I'm leaking back there so far so good.
The running boards I just ordered are 6.6 in wide. since my wife parks her CRV in the garage, I decided to replace the OEM boards with the TYGER BLADE. I also installed so paint matched Side moldings. I should be able to park anywhere without getting dinged. I used the wife's CRV as a guinea pig to see how much clearance I have before her door nails my painted parts.Thanks, it does. I was mostly wondering if it would stick out enough to protect the door from possible dings in parking lots
I’d almost prefer that to the leather, but my wife wanted leather.New Carhartt seat covers went on today. Pain in the ass install but great fit.
