Need advice on getting exhaust clamps to seal at joints.

[jdamtb918]

I recently installed CVF’s catted DP on my 21’ Ranger. The clamps they gave me to secure the both sides of the adapter pipe which is slotted on 3 sides. I do not have a 1/2” impact so I had to use ratchet to tighten the clamps. I also broke out the breaker bar to get them tighter but I’m still getting a leak from the outlet side of DP to the adapter pipe. Is there a trick to getting these slotted pipes to seal? What am I doing wrong? Any help would be much appreciated!

On the mid pipe side, CVF sent me two of the same size clamps so I assumed they messed up. I bought this other type of clamp at AutoZone. Not 100% sure if it’s sealed completely either

Sponsored

 

[Doc]

I recently installed CVF’s catted DP on my 21’ Ranger. The clamps they gave me to secure the both sides of the adapter pipe which is slotted on 3 sides. I do not have a 1/2” impact so I had to use ratchet to tighten the clamps. I also broke out the breaker bar to get them tighter but I’m still getting a leak from the outlet side of DP to the adapter pipe. Is there a trick to getting these slotted pipes to seal? What am I doing wrong? Any help would be much appreciated!

On the mid pipe side, CVF sent me two of the same size clamps so I assumed they messed up. I bought this other type of clamp at AutoZone. Not 100% sure if it’s sealed completely either

Put 1 layer of exhaust wrap and put the clamp back on..

EBAY
2 Roll x 2" 50FT Black Exhaust Wrap Header Manifold Fiberglass Heat Wrap Tape
C
carautopartshome
(32970)
99.6% positive
Seller's other itemsSeller's other items
Message

US $26.51/eaor Best Offer
Was US $30.13
Save US $3.62 (12% off)

 

[veedubtuner]

 

[IdahoRanger]

I couldn't even seal a gutter seam with that sh*t so not going to try it on a boat like in the commercial.

 

[AzScorpion]

Sponsored