Sponsored

DeeZee damper install question

port43

Well-Known Member
First Name
Tony
Joined
Dec 12, 2020
Threads
10
Messages
657
Reaction score
1,950
Location
Detroit Suburb
Website
childrescuecoalition.org
Vehicle(s)
2019 Ford Ranger STX FX4, 2017 Lincoln MKX, 2008 Harley XL 1200N, 1972 Pontiac LeMans Convertible
Occupation
Secret agent, man
I experienced the same thing. I simply "trained" the cable to fold to the other side of the strongarm.
It took only a couple of minutes to repeatedly fold the cable to the inside as I closed it.
I did this about 8 or 10 times and it now goes that way naturally.
Stop being competent!
Sponsored

 

AzScorpion

Moderator
First Name
Dave
Joined
Jul 25, 2019
Threads
335
Messages
26,288
Reaction score
132,405
Location
Back Home In AZ!
Vehicle(s)
2023 Ford Ranger Tremor
Occupation
Retired...Full Time Slacker
Has anyone noticed any kinks in their tailgate cable on the damper side? I've had mine on for a long time, and today noticed a kink in the cable, on the damper side, and the cable is slack. The opposite side is taut. Don't like this.
When I slowly closed the tailgate it seemed the cable was kinking at the damper shaft/cylinder area, which is about the center of the cable as seen in the pic. I'm sure there is only one way to install it, but now am wondering if the cable kinking is a design flaw or something else and happens every time you close the tailgate.

Tailgate.webp
I used a velcro tie on the cable to guide it around the damper so it doesn't get pinched between the damper and the body. Add some black tape below it so it doesn't move and you're gtg.

Velcro_Tailgate Strap.jpg
 
Last edited:

FoD

Well-Known Member
First Name
Terry
Joined
Jun 26, 2020
Threads
20
Messages
2,590
Reaction score
9,848
Location
Out There
Vehicle(s)
2019 Ranger XLT FX4
Occupation
Retired & Grandparenting 🤣
Vehicle Showcase
1
Has anyone noticed any kinks in their tailgate cable on the damper side? I've had mine on for a long time, and today noticed a kink in the cable, on the damper side, and the cable is slack. The opposite side is taut. Don't like this.
When I slowly closed the tailgate it seemed the cable was kinking at the damper shaft/cylinder area, which is about the center of the cable as seen in the pic. I'm sure there is only one way to install it, but now am wondering if the cable kinking is a design flaw or something else and happens every time you close the tailgate.

Tailgate.JPG
Don't know why anybody would have such wimpy wires for tailgate support...use these from a 1962 F100 series, never have to worry about kinks, just some scale/rust...:angel:

1611783274831.webp
 

JasonTremor

Well-Known Member
First Name
Jason
Joined
Feb 1, 2022
Threads
9
Messages
869
Reaction score
1,917
Location
Tennessee
Vehicle(s)
2021 Ranger Tremor XLT
I used a velcro tie on the cable to guide it around the damper so it doesn't get pinched between the damper and the body. Add some black tape below it so it doesn't move and you're gtg.

Velcro_Tailgate Strap.jpg
Thanks for the idea and I'm going to give this a try. Just noticed in the one week of damper ownership that my tailgate cable was getting roughed up by the damper.
Sponsored

 
 








Top