Sponsored

Before you remove top speed limiter

jrscobra

Active Member
First Name
Jaime
Joined
Apr 14, 2020
Threads
12
Messages
44
Reaction score
125
Location
Chattanooga
Vehicle(s)
2019 Ford Ranger lariat Crewcab
Occupation
Fleet Vehicle Sales at a Ford Dealership
Vehicle Showcase
1
Wouldn’t a driveshaft loop be a very smart add before adding horsepower and removing top speed limits? A dropped driveshaft can destroy a vehicle. Anyone? Thoughts?
Sponsored

 

J_D

Member
First Name
John
Joined
Jul 23, 2019
Threads
1
Messages
22
Reaction score
27
Location
California
Vehicle(s)
Ranger
I would be more worried about a low rated tire shredding it tread at high speed before the drive shaft.
Yes I lost the tread from a tire going over the rated speed. If there would have been a turn involved I probably would not been here now.
It was very violent and left me with what looked like a doughnut with steel belts.
 

P. A. Schilke

Well-Known Member
First Name
Phil
Joined
Apr 3, 2019
Threads
149
Messages
7,083
Reaction score
37,187
Location
GV Arizona
Vehicle(s)
2019 Ranger FX4 Lariat 4x4, 2020 Lincoln Nautilus, 2005 Alfa Motorhome
Occupation
Engineer Retired
Vehicle Showcase
1
Wouldn’t a driveshaft loop be a very smart add before adding horsepower and removing top speed limits? A dropped driveshaft can destroy a vehicle. Anyone? Thoughts?
Hi Folks,

Another back story....

When I was racing, I had some issues that I wanted to do a Sunday morning pre race emergency practice. The Stewards decided to combine us open wheel drivers with closed wheel (eg sedans). Since this was a short 10 minute practice, I was not thrilled but what the hey.... so off we went out onto the racetrack. I got in a solid lap to indicate the misfire in the motor was resolved, but on the second lap I came up on a production Lotus as we round the first turn at Mid Ohil Sports Course at a good speed. The lotus failed the front u joint and the driveshaft pole vaulted his rear end up in the air. I swerved by thowing the Supervee to driver's left and barely missed him slamming down behind me. Whew.! he did not have a driveshaft loop as required. Lucky I did not suffer any damage due to this failure of the technical inspectors that missed this requirement for a driveshaft loop. If you plan to go beyond the driveline's critical speed. You need a driveshaft loop... JMO!

Best,
Phil Schilke
Ranger Vehicle Engineering
Ford Motor Co. Retired
 
OP
OP
jrscobra

jrscobra

Active Member
First Name
Jaime
Joined
Apr 14, 2020
Threads
12
Messages
44
Reaction score
125
Location
Chattanooga
Vehicle(s)
2019 Ford Ranger lariat Crewcab
Occupation
Fleet Vehicle Sales at a Ford Dealership
Vehicle Showcase
1
Before I tune, I will add the loop. Its common sense and a very nice safety feature. Ive owned more cars than I can remember, and one thing that I can say is that my cars were pristine after years of ownership. Even when someone was faster than me for a while, they always ended up shredding their vehicles due to poor planning.

Build your rig to last. Doing it right will pay off!
 

Doc

Well-Known Member
First Name
Doc
Joined
Dec 24, 2018
Threads
94
Messages
5,766
Reaction score
23,226
Location
Live oak fla
Vehicle(s)
2026 5.0 Mustang GT, 2024 Ranger STX
Occupation
Retired
Before I tune, I will add the loop. Its common sense and a very nice safety feature. Ive owned more cars than I can remember, and one thing that I can say is that my cars were pristine after years of ownership. Even when someone was faster than me for a while, they always ended up shredding their vehicles due to poor planning.

Build your rig to last. Doing it right will pay off!
Where do you get one, or do you have to fab it ?
Regards
 


OP
OP
jrscobra

jrscobra

Active Member
First Name
Jaime
Joined
Apr 14, 2020
Threads
12
Messages
44
Reaction score
125
Location
Chattanooga
Vehicle(s)
2019 Ford Ranger lariat Crewcab
Occupation
Fleet Vehicle Sales at a Ford Dealership
Vehicle Showcase
1

dondonbabyraptor

Well-Known Member
First Name
Brandon
Joined
Jan 27, 2021
Threads
41
Messages
2,194
Reaction score
6,249
Location
San Diego
Vehicle(s)
2020 Ford Ranger Lariat
Occupation
I/O Psych MSc student
I’m a complete noob. Is there installation instructions for the driveshaft loop or a simple list I can follow from one of y’all? Any bolts/screws/washers/nuts I need to buy? Sorry for the dumb questions. Still learning here.
Sponsored

 
 








Top