Vr05 E "Graboid" 2021 Lariat Tremor Overland Build

[Vr22s]

So this might be a big picture heavy, but figured I browse and lurk here enough might as well show off my build. It's not quite done but it's about where it's going to be fore now.

I actually had this on my 2020 XLT FX4 before it was demolished by a red light runner....But with everything there is a silver lining and I was able to get me a Tremor earlier this year.

When I get the time and the hot weather calms down I am going to get her out onto something a little bigger than a curb.

Sponsored

 

[tremorman]

Awesome. Is that a factory tow package and which recovery shackle hitch is that?

 

[Vr22s]

Awesome. Is that a factory tow package and which recovery shackle hitch is that?

That is the factory Tow Package. and that shackle is just an Amazon Special. I did however replace the lock pin with something from ford.

 

[Stage3Motorsports]

Love it! Great looking Setup!

 

[Vr22s]

Finally got to take her out. Having the slightly higher ground clearance saved me on some trails.... Those hoop steps really need to go...

 

[syntheticreality]

Finally got to take her out. Having the slightly higher ground clearance saved me on some trails.... Those hoop steps really need to go...

How do you find the ease or difficulty of getting the bike in and out of the bed with that bed rack?

 

[Vr22s]

How do you find the ease or difficulty of getting the bike in and out of the bed with that bed rack?

It makes it a bit difficult, I have to angle it to get it in. Getting it out is a bit easier, just drop the tail gate and roll it forward.
With that though it is pretty minor issue to me, if I had to take two bikes that might be a problem with all my other cargo.
One day I want to get one of those hitch racks that sits a bit higher so it doesn't limit my departure angle.

On the plus side If I put the dropper post up a bit it's almost impossible to grab it quickly and run off with it. You actually would have to think about how you're going to get it out.

 

[HarryManback]

What did you use to create the upfitter switch labels? I need to do something for mine, and I like the size/font of those.

 

[Vr22s]

What did you use to create the upfitter switch labels? I need to do something for mine, and I like the size/font of those.

Sadly these came from a Trigger Six-Shooter aux power system, I had it on my other Ranger that passed away...and just decided they would be good use on the new one.

I am sure if you contacted you might be able to get a sheet of them.
However when it is dark they are impossible to see, I want to find something that might stand out a bit more..

Sponsored