Michigan Tom Woods 1pc driveshaft

[Yinzcity]

Tom Woods 1pc driveshaft. Installed begining of the year, removed it before trading in my Ranger for an F150. Definitely an improvement over the stock 2 piece driveshaft.
$300 local pickup only in the Detroit area.

Sponsored

 

[Chris M]

Tom Woods 1pc driveshaft. Installed begining of the year, removed it before trading in my Ranger for an F150. Definitely an improvement over the stock 2 piece driveshaft.
$400 local pickup only in the Detroit area.

Aren't those individually measured and created for each vehicle?

 

[Yinzcity]

Aren't those individually measured and created for each vehicle?

They do have you send in a measurement when you order one. However, there should be minimal variation between stock vehicles. This one was on my bone stock 2019 Lariat FX4. If you've got a lift kit, then yes, it's probably going to be the wrong length.

 

[Yinzcity]

Bump, reduced to $300.

 

[Dereku]

Highly interested even though I do not have any issues with my 2 piece.

 

[Dereku]

4 door or super cab?

 

[TJC]

I think the wheel base is the same for both.

 

[Northerner]

Exactly what I am looking for. Wish I was a little closer

 

[Stevedbvik1]

Tom Woods 1pc driveshaft. Installed begining of the year, removed it before trading in my Ranger for an F150. Definitely an improvement over the stock 2 piece driveshaft.
$300 local pickup only in the Detroit area.

I’m in GR and interested. I’ll PM you

 

[TJC]

That's is a great buy at your price point.

 

[Yinzcity]

4 door or super cab?

Sorry, must have had notifications off. It's off a 4 door/Super crew, but as someone has mentioned, I think the driveline length is the same for both configurations.

 

[Yinzcity]

Spring bump
Still available

 

[AndyMedic]

If it helps. You can post the length you ordered and someone can measure there truck. They can email Tim Woods to confirm fitment if different lengths. There is play built into each shaft.

I did this when I bought mine from another member and have had no issues.

 

[Yinzcity]

If it helps. You can post the length you ordered and someone can measure there truck. They can email Tim Woods to confirm fitment if different lengths. There is play built into each shaft.

I did this when I bought mine from another member and have had no issues.

I don't recall the exact number I measured when I ordered, but these are the measurements of the driveshaft as it sits today.
Near as I can tell from the grease marks, it was about 67" in running position. Fully collapsed, it's about 65.5". There is also a 3/8" spacer they send with the driveshaft that went between the flanges on the transmission end.

 

[TJC]

I don't recall the exact measurement of mine, but that is the ballpark range. A 2020 4x4 SCab. I think they are all the same size.

Sponsored