Power train control module has detected the vin profaned is not valid

[Cliff stanton]

This message popped up, after enabling hill decent control mod on FORScan. Has this happened to anyone else? Vin in abs module matches trucks. Set it back to factory code is still popping up. Any hints on how to correct?

Sponsored

 

[UncleBob]

My first thought was, 'Have you been making any modifications with ForScan?"

 

[RedlandRanger]

If you just restored the one value that might not fix it. You should restore the entire module configuration that you (hopefully) backed up before you made any modifications.

That would be my first suggestion on what to try.

 

[Big Blue]

I agree with @RedlandRanger try restoring the entire module first. Like he saids hopefully you backed up all your modules before making changes.

Just curious, where did you get the values you changed and which ones where they in what module(s). Also wondering why you felt you needed to change this, mine seems to be engaged all the time and especially noticeable in tow mode.

 

[Cliff stanton]

Got it fixed, reset all modules. Think the problem was I didn’t clear the DTC’s. Thanks for the advice

 

[Washingtonwarrior]

Got it fixed, reset all modules. Think the problem was I didn’t clear the DTC’s. Thanks for the advice

I might need help with this , I recieved the same thing and I took it to the dealer and they can’t figure it out ! I stopped by today and reverted all my settings back to stock so thier going to try again , but they have had it for a month and can’t figure it out . They put a new pcm In and nothing , then a bcm and nothing . I’m so over it

 

[Washingtonwarrior]

Got it fixed, reset all modules. Think the problem was I didn’t clear the DTC’s. Thanks for the advice

When you say reset all modules , are you saying you went through the whole system ? Bcm module, apim module ipc module etc …. Or just the one.
I’m trying to fix mine at the moment as well

Sponsored