Need some help pulled FX4 decals off and need measurements.

[RAYJAY]

hi all was cleaning up the truck and removed the FX4 decals to install different ones, forgot to mesure where they were located thanlks

Jeff

Sponsored

 

[Jamesb]

hi all was cleaning up the truck and removed the FX4 decals to install different ones, forgot to mesure where they were located thanlks

Jeff

DM me if you need more clarification.

 

[JaysOnTheEDGE]

Use some painters tape as a guide to mark where you want them on the truck. then you can match them up perfectly on both sides

 

[RAYJAY]

DM me if you need more clarification.

thank you the red factory decals just don't cut it on a red truck ... got these

 

[RAYJAY]

all done . think it looks a lot better than factory

 

[NvrFinished]

Looks nice! Is it one solid decal like the factory ones or separate pieces?

 

[RAYJAY]

Looks nice! Is it one solid decal like the factory ones or separate pieces?

fx4 is all one the small lettering is all separate wish decal is a flat finish

 

[Gizmokid2005]

I've been thinking about replacing my vinyl as well, so I decided to build a 1x1" "ruler" to figure out what size/where I would want the vinyl. Maybe it'll help you with this as well. (There are 1" gaps between the top and bottom rulers and the side ruler.)

 

[Bsenecal]

all done . think it looks a lot better than factory

Those look amazing.
Brian

 

[RAYJAY]

Those look amazing.
Brian

thank you

 

[RonG]

all done . think it looks a lot better than factory

 

[RonG]

 

[RonG]

turned my stock tremor decal to this one

Sponsored