California Fancy Pedal Covers

[quangdog]

All currently sold. If you are interested I can start another list for another run.

No rush for me - Reach out when you do start a new one, but no need to try to get a new list started just for me. Thanks!

Sponsored

 

[Ranger54]

No rush for me - Reach out when you do start a new one, but no need to try to get a new list started just for me. Thanks!

I would take some too!

 

[Shomare]

Brake replaces stock pad and the gas slips over the stock pedal.

Tips on installing

 

[Gizmokid2005]

Tips on installing

The gas pedal was a royal PITA. I suggest a tiny bit of dish soap around the edges which should help immensely. I just manhandled it for 10 minutes until it finally went on.

 

[Shomare]

This won’t be the popular method but I found that removing the gas pedal by taking off the four nuts and disconnecting the electrical connection made this whole process a lot easier.
Soaked the panel cover and as hot as I could get at tapwater, and use some hand sanitizer on the rubber and it helped it to slip on. The paint can opener and key to All the rubber up over the lip

 

[RCMUSTANG]

#1 quangdog
#2 Ranger54

 

[PltFX4]

#1 quangdog
#2 Ranger54

Please add me to the list PltFX4... Thanks.

 

[RCMUSTANG]

#1 @quangdog
#2 @Ranger54
#3 PltFX4

 

[Joyride]

Kind of late to the party, but interested in a set of pedals. Are these still available? If not , can you point me in the right direction. Thanks.

+1 Same here

 

[bzmotoninja83]

#1 @quangdog
#2 @Ranger54
#3 PltFX4

Ad me to this list please and thank you

 

[RCMUSTANG]

Sorry guys. I'm not doing any group orders anymore for any of the products I've found.

 

[JKocot]

The gas pedal was a royal PITA. I suggest a tiny bit of dish soap around the edges which should help immensely. I just manhandled it for 10 minutes until it finally went on.

Did you start from the top or bottom? Left or right side? The gas pedal has been driving me nuts for a week.

 

[Gizmokid2005]

Did you start from the top or bottom? Left or right side? The gas pedal has been driving me nuts for a week.

I honestly don't remember for certain, but I think it was the bottom, started where the trim was all around it and used the "cutout" as the last place to wedge on.

 

[Msfitoy]

Sorry guys. I'm not doing any group orders anymore for any of the products I've found.

That's too bad...were there some not so appreciative customers?

 

[JKocot]

I honestly don't remember for certain, but I think it was the bottom, started where the trim was all around it and used the "cutout" as the last place to wedge on.

Thanks!

Sponsored