Jackson84
Well-Known Member
- Thread starter
- #1
So I was given this led 20in light bar as a birthday gift to put in the front bumper, no acc to worry about, the bar uses factory holes and attaches perfectly however I am a vehicle wiring newbie. They sent me a wiring harness, with a relay as well as a 30 amp fuse that has a push button switch. I would like to use that to start and maybe in the next few months upgrade your the fascia switches between the 12v outlets under the a/c controls. Until then this is what I have to work with. I have a test light and volt meter but I don't know where to begin. I know there is a power and a ground but there are a few more connections besides what attaches to the light that are throwing me for a loop. Also getting the switch into the cab through the firewall or however...I'm drawing straws at this point. Any help is appreciated and if someone would like my cell number to explain it I'd be more then willing to listen
! I'll attach the pictures of all the components. Thanks in advance for any help!
Sponsored