Lane Assist Issue

[Ranger X]

Has anyone had problems with selecting the Aid & Assist option in the information center. I have to keep selecting it every time I drive the vehicle, it won’t default to the previous selection

Sponsored

 

[P. A. Schilke]

Has anyone had problems with selecting the Aid & Assist option in the information center. I have to keep selecting it every time I drive the vehicle, it won’t default to the previous selection

Hi Bruce,

Been a while for me but I thought it was Warn and Assist. I chose Warn only as I do not want the truck assisting me on lane keeping.

best,
Phil Schilke
Ranger Vehicle Engineering
Ford Motor Co. Retired

 

[Ranger X]

Yes sir you are correct, warn and assist... I just wish I didn’t have to go into the lane keeping section every time I start the truck, seems a little redundant

maybe I’m missing something here?

 

[Trigganometry]

Yes sir you are correct, warn and assist... I just wish I didn’t have to go into the lane keeping section every time I start the truck, seems a little redundant

maybe I’m missing something here?

Out of curiosity, are you on the latest version of software? Did you do a system reset? These settings should take to what ever you set them at and remain that way. Not sure if you’re selecting these changes while system is active or switched off from the turn signal switch. In mine I make adjustments while it is off. Then switch it on and they’re good. Hope that helps

 

[Ranger X]

Tried selecting while in the “off” position like you said to no avail. Purchased new two weeks ago. Will check software next. Thanks

 

[Cape Cruiser]

Yes sir you are correct, warn and assist... I just wish I didn’t have to go into the lane keeping section every time I start the truck, seems a little redundant

maybe I’m missing something here?

Bruce, I think you need to hit the end of the turn signal switch which will turn it off if you want it off. Bret

 

[rang19ca]

I leave mine on just the warning only.

 

[Ranger X]

are you using a key set up to the My Key functions?

Yes I am using the my key function and I discovered that when I disable

are you using a key set up to the My Key functions?

yes I am using the my key function and I discovered that when I disable the my key the lane keeping mode stays as I have selected “alert and assist”

thank you all for your input!

Sponsored