BedRug discount for forum members?

[AzureRanger]

I've thought of a rubber bed mat over the BedRug if I was dropping engine blocks into the bed, but that would hold water under it. I find that the BedRug can smell musty if I leave it wet (mainly from kayak swamp water). So I make sure to open the tonneau regularly.

As far as a snug fit, I agree, I can push in on the sides and front, it doesn't suck up against the bed, which would be nice.

BUT ... the sculpted nature of the BedRug makes it look like it's a tight fit.

That sagginess doesn't impact actual use, it's not like I lean against it, sink in a few inches, and fall over. But, like you, that lack of being super tight is a concern but, in reality, never is an issue.

I've had a few people see it and comment on how nice it looks, and it is sharp looking in my opinion.

And it really does clean up very nicely. I've had dirt heaped into the bed and then ground into it and it comes out great with the pressure washer.

LOL, when I use the soap cannon, it does take forever to rinse it so that the water runs perfectly clear (not saying I'm OCD or anything!). =)

It also vacuums with a shop vac very nicely.

And then there is the grief I catch from my brother for putting "carpet" in my pickup bed

Sponsored

 

[subquark]

And then there is the grief I catch from my brother for putting "carpet" in my pickup bed

You'll see that you need it, if you install a damper.

You're truck becomes a babe magnet and a carpeted bed ain't so bad! =p

cue Aerosmith's Dream On ...

 

[Stage3Motorsports]

Waiting on my '23 XLT Ranger and I plan to purchase a BedRug liner. Are there discounts available to ranger5g forum members?

Thanks.

Feel free to PM me

 

[Rod B]

What soupie said.
I absolutely love mine. First time trying one and was pretty nervous. I’ll buy another In a heart beat if I replace the truck.
Advice I can offer is to look at each picture at where they have the tape several times while applying; take your time and make sure their position is right. get a bottle of alcohol and a couple microfIber rags and definitely don’t miss any spots where the tape goes. I seem to remember two small spots where it was off a little. I know the tail gate was one because I used extra there to help.

Sponsored