No but people on here have. It’s a little hard with the shape but can be done.Did you tint yours? If so post a pic
Hey, very cool looking, are those with BLS ??Like this...
lucky. I tried to import 2 different tail lights, and both did not fit. I wish we could get an aftermarket option.No, we dont have Bliss on our Rangers in Australia..
Which ones did you try?lucky. I tried to import 2 different tail lights, and both did not fit. I wish we could get an aftermarket option.
I tried 2 different sets I found online. we have 3 problems, the first is the connector which like you said, I could work around by cutting off and soldering, but then problem 2, the top corner of our lights is straight across, the top corner of theirs are curved, and third there is no where to put the clips we need to make our light snap back in properly.Which ones did you try?
I was going to do the same thing & "import" a set from Asia...
Was it the connectors? Is there a way to cut-off our plug connector and hard-wire into the import connections?
Any pics?
So Ford did "tweaks here & there" where we couldn't swap parts out with the international trucks =(I tried 2 different sets I found online. we have 3 problems, the first is the connector which like you said, I could work around by cutting off and soldering, but then problem 2, the top corner of our lights is straight across, the top corner of theirs are curved, and third there is no where to put the clips we need to make our light snap back in properly.