Search results

When it slows down on mine i clean the glass inside and out and it goes back to normal.

Thanks. It is from them not sure who else has one.

Third intake system. This one will end up sealing up with the hood scoop. Just need to get the replacement lid made. Fit and finish is better than the first 2 I had.

Finally got the hood wrapped to match and replaced my homemade ditch light brackets with a store bought set.

I ordeed the front one from ebay and the wrong gears were on the box. I counted the ring and pinion teeth and verified they were wrong.

That's an installer problem there. No one else has had issues.

Even with only 33's it drives so much better in every aspect.

Even though the fiberglass hood is lighter it's still nice to have the struts back after warranty.

That's close to the one used on the middle strip but the front is definitely different. Problem is making sure they're the same size since they don't list them separately. I'll just go to the dealer and see if they have or know which ones they are.

Every diagram i see lists the complete strip and clips. No clips separately. The one at the leading edge of the hood and the one in the middle. Those are the only 2 that uses clips to attach.

Any chance you know which ones are the ones for the 2 underhood weatherstrips?

Good news: I got the new compressor in since the old one died and found the multiple air leaks. One was an elbow that actually rotted through. Bad news: one of the leaks was the pressure switch and no one has one in stock. Half way done. Also installed a replacement underhood light on the...

Replaced the supplied bolts with studs and nylock nuts like factory but in stainless steel.

Took a can and a half but the underside is covered. Just need to wrap the top and it's done.

As I was prepping the vent area for paint it crumbled away on this corner. It was too thin from manufacturing. Bondoglass to the rescue. I'll have the lines cleaned up when it gets wrapped.

Had custom shirts made of my 3 vehicles. This one finally showed up.

It's a bit lighter. I could tell when removing and installing. Maybe 10-15 lbs.

I'm itching to get the vents painted black and wrapping it to match the rest of the truck.

Since my hood supports died i felt like the hood was still too heavy even though it's aluminum 50 lbs. Still gonna warranty the supports and replace them. I decided to get one of them fancy fiberglass ones. The fit was pretty good. I did have to put my ditch light bracket between the hood...

Some was done with Sawzall and grinder. You can use whatever you have available for cutting metal. Just might take a bit longer.