Search results

Are there these for our trucks?

Can this be done in the Ranger world? Has anyone done it? Some in the F150 world are swapping the 4x4 rear axle blocks (the ones between the rear axle and spring) for the ones from a two wheel drive effectively almost leveling the truck. Thanks George

A number of you have put lights in the fender vents. It is a look I really like. I did some searching and did not find any info regarding what lights wee used of source for those lights. I know there are some after market vents with lights but I like the stock vents better. Could some one...

Saw a Ranger this morning with lights outlinning the grill nostrils. Really caught my attention and looked sharp. Has anyone here ssen one? Has anyone lighted theirs? EDIT. Guess I should have looked, they are all over ebay.

Can any of the control modules be accessed via the on-board modem? Basically I am wondering the truck could be hacked via this modem. Thanks George

What is the secret to removing the IP cover to access the cabin fuse box? Sure do not want to break it. Thanks George

Anyon who purchased one, how did you do it? I contacted them through their website over a week and a half ago with no response.

Thoughts opinions on this from Autoventshade. https://www.autoventshade.com/aerocab-marking-light/2021/ford/ranger Found it looking at window visors. Thanks.

I never noticed this before. Do you see the rear bunper and trailer hitch receiver in tne backup camera? If not how can I change it.

I have looked at several U-Tube videos on removing them to gain access to the turn signal bulbs but do not see the clips they refer to lifting/pressing to release them. Are the mirrors different on a 2021 than on the earlier MY (2019/2020)? Thanks

I had the dealer replace my rear bumper cover under warranty because the ends were very close as in almost touching the tailgate when it is open. You could actually see the bow in the back edge. Well the new one is actually a lttle worse in that at the license plate it actually touches my...

I have been wanting a Putco Tailgate Lightbar since I got mt '21 Ranger. Problem has been that the bumper cover ia bowed closer to tailgate when down on the ends than in the middle so no clearance for lightbar. I went to my Ford dealer's body shop today. Body shop Asst Mgr said they could...

Does any know if you can tap into ghe brake light circuit behind the brake light without causing any problems with electronics? I have a Lariat with the full boat of electronics. I know you can.t tap in at the trailer plug. Thanks

Has anyone taken the plunge and purchased one? I would like to get one except clearance to the tailgate when closed and when closing is extremely tight and the bedside ends. It is too expensive to take the plunge and not be able to install it.

I want to paint my tailgate handle to match the door handles which are body color. The current handle has a slight texture so it would likely not come out smooth. I see that there is a different part number for the '19 & '20 models vs the '21 models. Does anyone know if there is any...

I have 21 Lariat with BLISS. Thinking about putting some lights above the license plate similar to what Msfitoy did. The ones I am thinking about using function both as tail lights and brake lights. Tail lights I would connect to license plate lights. Would connecting the brake lights to the...

I would like to paint my tailgate handle to match my truck. Door handles match but tailgate handle is black. If you painted yours what did you do, did you sand it to get it smoother or just use adhesion promoter, prime, paint and clear coat? Some close up pics would be great. TIA George

I want to paint my tailgate handle to match my truck. How complicated is it to remove? I thought I would just buy one in color but the service part is indicated as paint to match. Thanks.

The new, plug and play I believe, tailgate light bar is available according to Putco customer service. I was planning to order one. I checked for available space when I had the tailgate open. With the tight clearance tailgate to the license plate and the and the camera cable I do not think...

Several months ago I put chrome bulbs in my turn signals to get rid of fried egg look. Apparently I did not seat the one on the passenger side fully and it came out of the socket an fell into the light. Could no fish it out. Put in a regular bulb and plan to remove the headlight assembly in...