coblueberryranger
Well-Known Member
Looks like you guys got these in according to your facebook/instagram story? Sending some orders out?
Sponsored
Yep most of them will be going out today, got dropped of to us after shipping cutoff yesterday.Looks like you guys got these in according to your facebook/instagram story? Sending some orders out?
Thanks again! I got tracking notification this morning. Guess I have parts to install in between the supposed rain next weekYep most of them will be going out today, got dropped of to us after shipping cutoff yesterday.
Your Welcome! New parts install days are the best days!Thanks again! I got tracking notification this morning. Guess I have parts to install in between the supposed rain next week
Hey Troy, I have a little provlem with the Ss3 pros thst came in. Box was pretty thrashed but I wasn't too worried about that, but mine didn't come with any of the mounting hardware or wiring pigtails. Explains why they moved so much during shipping since the ss3 fogs barely moved.
We are very sorry about that I have PM'd you for order info, and we have forwarded this onto Diode Dynamics about the box condition and missing parts. Once I have the order info we will get the missing parts out to you in a timely manner.
Your Welcome!Thanks for taking care of this Troy!
Just to update everyone, Panda Motoroworks and Diode send me the missing parts very promptly, they showed up last friday. Thanks again and I'll be getting them wired up this weekYour Welcome!
I used some washers to space it away from the housing so that I could have more adjustmentAnyone have any recommendations upon installing about getting the fog lights to aim lower? They seem a bit high to me and loosening them up and aiming the other set screws so the housing is point as much down as it can. I think I put my set screws towards to pull the housing closer to the front of the light and aimed down but maybe I ought to pull them back a bit to get the aim down. just seems like when I tighten the torx it always aims high and mixes with my headlights more than I'd expect.
Just on the bottom screws or all 4?I used some washers to space it away from the housing so that I could have more adjustment
I had generic washers, so I think I used 2 in each corner to give it just enough wiggle roomJust on the bottom screws or all 4?