RAYJAY
Well-Known Member
- First Name
- Jeff
- Joined
- Aug 3, 2020
- Threads
- 22
- Messages
- 411
- Reaction score
- 628
- Location
- UNION DALE PA
- Vehicle(s)
- 2020 ranger pickup 2019 subaru
what quick connector are you using to tap into the high beam wire ?
Sponsored
Sponsored
Various tapping sources for triggers.
- Thread starter OFC Ranger
- Start date
- Watchers 3
OP
OP
OFC Ranger
Well-Known Member
- Thread starter
- #17
I just picked the driver side bulb harness and did a waterproof splice for the trigger wire to the relay.
RAYJAY
Well-Known Member
- First Name
- Jeff
- Joined
- Aug 3, 2020
- Threads
- 22
- Messages
- 411
- Reaction score
- 628
- Location
- UNION DALE PA
- Vehicle(s)
- 2020 ranger pickup 2019 subaru
doing the same to mine going to run 2 relay off of one trigger that should be ok ?
OP
OP
OFC Ranger
Well-Known Member
- Thread starter
- #19
Yes, daisy chaining the trigger is perfectly fine.
RAYJAY
Well-Known Member
- First Name
- Jeff
- Joined
- Aug 3, 2020
- Threads
- 22
- Messages
- 411
- Reaction score
- 628
- Location
- UNION DALE PA
- Vehicle(s)
- 2020 ranger pickup 2019 subaru
TY Pa has a different law here for inspection ... have to have all of my xtra lights on low beam only so have to make up a a switch box with high and low beam trigger. been adding lights a long time and never heard of doing light on a low beam ... had to even remove bambi mode from the truck to get it to pass this time ......
Sponsored
