OFC Ranger
Well-Known Member
- Thread starter
- #1
The ol' Ranger might be getting a proper home in the next few months.
Looking to get an 18x26x9 enclosed garage with a 10x8 cut out on the front to eventually install a roll up door (cost savings right now). About everywhere I look is averaging $5,000 with delivery included. Will be installed on a rock crush run pad that is framed by landscaping blocks. Again a cost measure thing, concrete would double the cost and I got a surplus of stone to frame the pad out. I would go with 8 foot legs, but I think 9 foot legs are the minimum requirement to install an 8 foot tall cut out. Ill have to double check.
My current garagezebo is 12x30 so I'm loosing 4 feet on the rear but gaining a little less than 6 feet on each side. I may make the cut out on the front offset just enough to easier passenger door entry, but give me more usable space on the opposite side.
Anyone running a metal building for vehicle storage?
Looking to get an 18x26x9 enclosed garage with a 10x8 cut out on the front to eventually install a roll up door (cost savings right now). About everywhere I look is averaging $5,000 with delivery included. Will be installed on a rock crush run pad that is framed by landscaping blocks. Again a cost measure thing, concrete would double the cost and I got a surplus of stone to frame the pad out. I would go with 8 foot legs, but I think 9 foot legs are the minimum requirement to install an 8 foot tall cut out. Ill have to double check.
My current garagezebo is 12x30 so I'm loosing 4 feet on the rear but gaining a little less than 6 feet on each side. I may make the cut out on the front offset just enough to easier passenger door entry, but give me more usable space on the opposite side.
Anyone running a metal building for vehicle storage?
Sponsored