Getting Wires into the Cab

[bkurtin]

I'm about to install backup beep beep proximity sensors on my back bumper of my 2019 Ranger XL and have to run a wire into the display which I'll place on the dash or in the center console storage area. Any idea of a relatively easy way to do this? I can run the wire underneath and into the engine compartment pretty easily. The trick is getting it somewhere near the console. Any idea? I know...I have a backup camera already but on my Fusion I have both the camera and the beep which I really like.

Sponsored

 

[painter1]

Hey,
I just happen to have this Ranger doc open so I'll link it. See page 23
https://madocumentupload.marketinga...6abfe59f374bccccc140bb8be7bd798e8468&v5=False

There might be a few grommets thru the floor pan also, IDK.

Hope that helps.

 

[bkurtin]

Hey,
I just happen to have this Ranger doc open so I'll link it. See page 23
https://madocumentupload.marketinga...6abfe59f374bccccc140bb8be7bd798e8468&v5=False

There might be a few grommets thru the floor pan also, IDK.

Hope that helps.

Hugely helpful. Page 23 showed me some grommets. Not in perfect locations but it will go a long way to making my life easier. I crawl under and take a look for thru the floor. Many many thanks.

Sponsored