FOR-11CK for 2020 Ranger

[rjc-eel]

was looking to get this no-cut adapter but noticed on amazon it only went up to 2019.

I have seen where some say the 2020's have a different plug

was able to get my scope up behind the dash but couldn't get a good look at the plug on my radio unit.

Has anyone successfully accomplished an install with this T adapter on a 2020?

thanks

Sponsored

 

[jrnm]

Works fine with model year 2020. Just did this 2 weekends ago.

 

[gryder]

Hey jrnm, old topic but did you use the FOR-11CK on an xlt 4 inch screen or the 8 inch screen?

 

[Doc]

Hey jrnm, old topic but did you use the FOR-11CK on an xlt 4 inch screen or the 8 inch screen?

What is FOR-11CK ?

 

[Johnv1991]

What is FOR-11CK ?

Wiring harness for adding an amp inline with the head unit so you don’t need to cut factory wiring.

 

[Doc]

Wiring harness for adding an amp inline with the head unit so you don’t need to cut factory wiring.

Thanks !

 

[y2krtaf]

Is this cheaper and or better than plug and play kits
https://plugnplaykits.com/search?type=product&q=Ford+Ranger

 

[jrnm]

Hey jrnm, old topic but did you use the FOR-11CK on an xlt 4 inch screen or the 8 inch screen?

Used this for the 8 inch screen in a XLT.

 

[tay]

How do you connect the FOR-11CK harness to an LC2i to connect a sub and amp ?

 

[jrnm]

I am unsure how to do this, as I just hooked it up to a kicker key mini amp to run the door speakers.

 

[Superspirit]

To hook up an amp and sub, you'll have to remove all the dash trim, remove the screen 4 or 8" won't matter. Remove audio control module and unplug. Plug 1 end of t harness into acm then other end back to factory harness. Use the wiring from the radio ( acm) side of harness to go to amp and lc 2 then use the wiring going into dash harness for speaker wires. Serval write ups in the electronics section.

Sponsored